SDS

Page 3 of 6
Product Description: MATERIAL SAFETY DATA SHEET
T20086APC-TU6
HSB TAN TEXTURE (SPE - Paint: 1 Oz. or Less)
PMS WARM GRAY 1C
METHODS OF CONTAINMENT: Absorb spilled liquid in suitable material.
METHODS OF CLEAN-UP: Use spark-proof tools to sweep or scrape up and containerize.
OTHER INFORMATION: Ventilate the area.
SECTION 7: HANDLING AND STORAGE
HANDLING:
Prevent buildup of vapors; use with adequate ventilation. Keep from sparks, heat,
flame or other heat sources.
Keep container tightly closed while not in use.
STORAGE:
Store in dry, well-ventilated area and in accordance with federal, state, and local
regulations. Do not expose to heat or store at temperatures above 48 C (120 F).
If storing in cold temperatures, allow product to warm to room temperature before use.
SECTION 8: EXPOSURE CONTROLS/PERSONAL PROTECTION
EXPOSURE GUIDELINES
# COMPONENT ACGIH TLV-STEL ACGIH TLV-TWA OSHA PEL-TWA
1 XYLENE 150 ppm 100 ppm 100 ppm
2 ETHYL ESTER 100 ppm 50 ppm 50 ppm
3 *ETHYLBENZENE 125 ppm 100 ppm 100 ppm
4 N-BUTYL ACETATE N/E 150 ppm 150 ppm
*See Section 15 and Section 11
ENGINEERING CONTROLS: Not generally required if product is applied in small quanti-
ties. If product is applied in larger quantities, provide ventilation to keep air
contamination below OSHA permissible exposure limits and ACGIH TLV exposure limits.
EYE/FACE PROTECTION: Wear safety glasses with side shields. Have eye wash facilities
immediately available.
SKIN PROTECTION: Chemical resistant gloves if contact is likely.
RESPIRATORY PROTECTION: A NIOSH-approved respirator may be necessary if exposure
cannot be controlled within applicable limits.
GENERAL HYGIENE CONSIDERATIONS: Wash thoroughly after handling.