Full Product Manual
Table Of Contents
- Owner's Manual
- Table of Contents
- INTRODUCTION
- READ THIS MANUAL THOROUGHLY
- SAFETY RULES
- General Information
- Operation
- 2.1 KNOW THE GENERATOR
- 2.2 HOURMETER
- 2.3 CONNECTION PLUGS
- 2.4 HOW TO USE THE GENERATOR
- 2.5 DON’T OVERLOAD THE GENERATOR
- 2.6 WATTAGE REFERENCE GUIDE
- 2.7 BEFORE STARTING THE GENERATOR
- 2.8 STARTING PULL START ENGINES
- 2.9 STARTING ELECTRIC START ENGINES
- 2.10 STOPPING THE ENGINE
- 2.11 LOW OIL LEVEL SHUTDOWN SYSTEM
- 2.12 CHARGING THE BATTERY (ELECTRIC START UNITS ONLY)
- Maintenance
- Troubleshooting
- Notes
- Manual Part No. 0K0172
- Manual del propietario
- Índice
- INTRODUCCIÓN
- LEA ESTE MANUAL MINUCIOSAMENTE
- REGLAS DE SEGURIDAD
- Información general
- Funcionamiento
- 2.1 CONOZCA EL GENERADOR
- 2.2 HORÓMETRO
- 2.3 ENCHUFES DE CONEXIÓN
- 2.4 CÓMO USAR EL GENERADOR
- 2.5 NO SOBRECARGUE EL GENERADOR
- 2.6 GUÍA DE REFERENCIA DE POTENCIA EN WATTS
- 2.7 ANTES DE ARRANCAR EL GENERADOR
- 2.8 ARRANQUE DE MOTORES CON CABLE DE ARRANQUE
- 2.9 ARRANQUE DE MOTORES CON ARRANQUE ELÉCTRICO
- 2.10 PARADA DEL MOTOR
- 2.11 SISTEMA DE APAGADO POR NIVEL DE ACEITE BAJO
- 2.12 CARGA DE LA BATERÍA (UNIDADES CON ARRANQUE ELÉCTRICO SOLAMENTE)
- Mantenimiento
- Resolución de problemas
- Notas
- Manual Parte No. 0K0172
- Manuel d'entretien
- Table des matières
- INTRODUCTION
- LIRE ATTENTIVEMENT CE MANUEL
- RÈGLES DE SÉCURITÉ
- Informations générales
- Fonctionnement
- 2.1 CONNAÎTRE LE GÉNÉRATEUR
- 2.2 HOROMÈTRE
- 2.3 PRISES DE CONNEXION
- 2.4 COMMENT UTILISER LA GÉNÉRATRICE
- 2.5 NE PAS SURCHARGER LA GÉNÉRATRICE
- 2.6 GUIDE DE RÉFÉRENCE DE WATTAGE
- 2.7 AVANT DE DÉMARRER LA GÉNÉRATRICE
- 2.8 DÉMARRER LES MOTEURS À DÉMARRAGE MANUEL
- 2.9 DÉMARRER LES MOTEUR À DÉMARRAGE ÉLECTRIQUE
- 2.10 ARRÊTER LE MOTEUR
- 2.11 SYSTÈME D'ARRÊT DE NIVEAU BAS D'HUILE
- 2.12 CHARGER LA BATTERIE (APPAREILS À DÉMARRAGE ÉLECTRIQUE SEULEMENT)
- Entretien
- Dépannage
- Remarques
- Manuel, référence 0K0172
6
Figure 2C - Control Panel (CSA Models)
20
9A
19
3
2
1
Figure 3 - Generator Controls
17
18
6
5
11
15
16
Figure 4 - Generator Controls
2.2 HOURMETER
The Hourmeter tracks hours of operation for scheduled maintenance
(Figure 5):
There will be a "CHG OIL" message every 100 hours. The message
will flash one hour before and one hour after each 100 hour
interval, providing a two hour window to perform service.
This message will actually begin flashing at 99 hours and disable
itself at 101 hours again, providing a two hour window to perform
the service.
Every 200 hours the "SVC" icon on the lower left hand corner of
the display will flash. The message will flash one hour before and
one hour after each 200 hour interval providing a two hour window
to perform service.
Figure 5 – Hourmeter
HOUR GLASS
GRAPHIC
RESET BUTTON
(IF EQUIPPED)
0000.0
When the hour meter is in the Flash Alert mode, the maintenance
message will always alternate with elapsed time in hours and
tenths. The hours will flash four times, then alternate with the
maintenance message four times until the meter resets itself.
• 100 hours - CHG OIL — Oil Change Interval (Every 100 hrs)
• 200 hours - SVC — Service Air Filter (Every 200 hrs)
Note:
The hour glass graphic will flash on and off when the engine
is running. This signifies that the meter is tracking hours of
operation.
2.3 CONNECTION PLUGS
2.3.1 120 VAC, 20 AMP, DUPLEX RECEPTACLE
This is a 120 Volt outlet protected against overload by a 20 Amp
push-to-reset circuit breaker (Figure 6). Use each socket to power
120 Volt AC, single phase, 60 Hz electrical loads requiring up to a
combined 2400 watts (2.4 kW) or 20 Amps of current. Use only
high quality, well-insulated, 3-wire grounded cord sets rated for
125 Volts at 20 Amps (or greater).
Keep extension cords as short as possible, preferably less than
15 feet long, to prevent voltage drop and possible overheating of
wires.
Operation