Use and Care Manual

Maintenance
EcoGen Automatic Standby Generator Owner’s Manual 19
4.5.1— Check Enclosure Louvers
1. Verify that intake and exhaust louvers and openings are clean and unobstructed.
2. Wipe exterior surfaces clean using a damp cloth.
3. Loosen dirt, oil, etc. with a soft bristle brush.
4. Remove loose dirt and debris using a vacuum cleaner, or low pressure compressed air (not exceeding 25 psi).
NOTE: Periodically wash and wax enclosure using automotive type products. Frequent washing is recom-
mended in salt water/coastal areas.
4.5.2— Check Lines and Connections
Perform a general inspection as follows:
4.5.3— Check Engine Oil Level
1. Remove dipstick and wipe with a clean cloth. See A of Figure 4-1.
2. Completely insert the dipstick and then remove it.
Figure 4-1. Check Engine Oil Level
3. Verify that the oil level is at or near the FULL mark.
4. If necessary, slowly add the recommended type of oil into the dipstick tube until the level is at the FULL mark. DO
NOT OVERFILL. See B of Figure 4-1.
5. Install dipstick.
Never operate the engine with the oil level below the ADD mark on the dipstick. Doing so could damage
the engine.
Hot oil may cause burns. Avoid prolonged or repeated skin exposure with used oil. Thoroughly wash
exposed areas with soap.
Any attempt to crank or start the engine before it has been properly serviced with the recommended oil
may result in an engine failure.
• Check Fuel Lines and Connections for Leaks • Check Oil Lines and Connections for Leaks
-30
°F
-20 -10 0 10 20 30 40 °C
-20 -10 0 10 20 4032 60 80 100
Temperature Range of Expected Use
SAE 30
10W-30
Synthetic 5W-30
A B
Engine Oil Recommendations
*
*
*