Installation Instructions

ManualsBrandsGenerac ManualsAccessories30-Amp Raintight Aluminum Plug in Box

Optional FLIP LID For Power Inlet Boxes

MODEL 6393

For Power Inlet Box Models 6336, 6337, 6338 and 6342, 6343, 6344:

Warning: Installation of this Power Inlet Box and related wiring must be done by a qualified electrician in compliance with all applicable electrical codes. Power

Inlet Boxes provided with circuit breakers are designed for locations where the authority having jurisdiction has deemed that a “permanently installed generator

outdoors” is considered to be a separate structure, thus requiring a service entry disconnect.

This optional Flip Lid is intended for applications when covering the power inlet is desired,

such as to keep out nesting insects, dirt, moisture, etc. Power Inlet Box sold separately.

Installing Optional Flip Lid with Power Inlet Box

Tools required:

1/4" nut driver

Flat Blade or Phillips Screwdriver

Included in This Kit:

Flip lid and rubber gasket

3 x 8-32 x .75 thread-cutting screws

ASSEMBLY INSTRUCTIONS:

NOTE: This Flip Lid MUST be installed PRIOR to wiring

the Power Inlet Box.

1. Open the Power Inlet Box by removing the screw or

hex nut on front of unit. Installation is easier if there is

enough space available to remove the bottom plate (by

removing the 4 screws).

2. Loosen “Green” screw on inlet and pull out green wire.

If the Power Inlet Box is already installed/wired,

remove the other screws securing the other wires.

3. Remove flanged inlet from the bottom of the Power Inlet

Box by removing (3) 8-32 screws on flange lip. Discard

screws.

4. Line up flip lid with the three (3) holes on the bottom of

the Power Inlet Box where the screws in Step 3 were

removed.

5. Insert three 8-32 x .75 screws through the inlet flange

and through the flip cover and into Power Inlet Box

bottom holes, and tighten evenly. Ensure gasket is

wrapped around the inlet and not pinched. Note: If

bottom plate was not able to be removed, pull all four

wires through the hole in the bottom plate and secure to

inlet after it is slipped into the Flip Lid.

6. Wire the inlet per step (4) in Power Inlet Box installation

instructions (opposite side).

7. Torque to 10 lb. inches.

8. After Flip Lid installation, complete Power Inlet Box

installation following instructions found on opposite

page.

Generac Power Systems, Inc.

Alpharetta, GA

Toll Free: 1-888-GENERAC

www.generac.com

0197020SBY

PN 500514 Rev A