Full Product Manual
Table Of Contents
- iQ2000 Portable Generator Owner’s Manual
- Generador portátil iQ2000 Manual del propietario
- Índice
- Sección 1 Introducción y seguridad
- Sección2 Información general y configuración
- Conozca su generador
- Información sobre emisiones
- Enchufes de conexión
- PowerDial
- PowerBar (Barra de potencia)
- Interruptor de economía
- Luces de estado del generador
- Indicador de tiempo de funcionamiento
- Sensor de combustible y medidor de combustible
- Retiro del contenido de la caja
- Cómo añadir aceite de motor
- Combustible
- Sección 3 Operación
- Preguntas sobre funcionamiento y uso
- Antes de poner en marcha el motor
- Preparación del generador para el uso
- Conexión a tierra del generador cuando se usa como unidad portátil
- Conozca los límites del generador
- Transporte e inclinación de la unidad
- Puesta en marcha de motores con arranque con tirador
- Volver poner en marcha motores calientes
- Sistema de parada por nivel de aceite bajo
- Funcionamiento en paralelo
- Sección 4 Mantenimiento y resolución de problemas
- Pieza núm. 0L5110
- Générateur portatif iQ2000 Manuel de l'utilisateur
- Table des matières
- Section 1 Introduction et sécurité
- Section 2 Renseignements généraux et installation
- Connaître le générateur
- Renseignements relatifs aux émissions
- Fiches de branchement
- PowerDial
- Barre d'alimentation
- Commutateur Économie
- Voyants d'état du générateur
- Affichage du temps de fonctionnement
- Capteur de niveau de carburant et jauge de carburant
- Ouverture de la boîte de l'appareil
- Ajoutez de l'huile à moteur
- Carburant
- Section 3 Fonctionnement
- Utilisation et questions liées à l'utilisation
- Avant le démarrage du moteur
- Préparation du générateur avant l'utilisation
- Mise à la terre du générateur lorsque celui-ci est utilisé de manière portative
- Connaître les limites du générateur
- Transport et inclinaison de l'appareil
- Démarrage du moteur à démarrage manuel
- Redémarrage d'un moteur chaud
- Système d'arrêt en cas de niveau d'huile bas
- Fonctionnement en parallèle
- Section 4 Entretien et dépannage
- Pièce No 0L5110

Owner’s Manual for Portable Generator 13
Inspect Engine Oil Level
Inspect engine oil level prior to each use, or
every 8 hours of operation.
1. Place generator on a level surface.
2. Clean area around oil fill.
3. See Figure 4-1. Remove oil fill cap and
wipe dipstick clean.
Figure 4-1. Engine Oil Fill
4. Screw dipstick into filler neck. Remove
dipstick and verify oil level is within safe
operating range. See Figure 4-2.
Figure 4-2. Safe Operating Range
5. Screw funnel into oil fill opening. Add rec-
ommended engine oil as necessary.
6. Replace oil fill cap and hand-tighten.
NOTE: Some units have more than one oil fill
location. It is only necessary to use one oil fill
point.
Change Engine Oil
When using generator under extreme, dirty,
dusty conditions, or in extremely hot weather,
change oil more frequently.
NOTE: Don’t pollute. Conserve resources.
Return used oil to collection centers.
Change oil while engine is still warm from run-
ning, as follows:
1. Place generator on a level surface.
2. Disconnect the spark plug wire from the
spark plug and place the wire where it
cannot contact spark plug.
3. Clean area around oil fill, and oil drain
plug.
4. Remove oil fill cap. Screw funnel into oil fill
opening. See Figure 4-3.
5. Tip unit and drain oil completely into a suit-
able container.
6. Slowly pour oil into oil fill opening until oil
level is between L and H marks on dip-
stick. DO NOT overfill.
7. Install oil fill cap, and finger tighten.
8. Wipe up any spilled oil.
9. Properly dispose of oil in accordance with
all applicable regulations.
Figure 4-3. Oil Fill Opening With Funnel
Air Filter
Engine will not run properly and may be dam-
aged if run with a dirty air filter. Service air fil-
ter more frequently in dirty or dusty conditions.
To service air filter:
1. See Figure 4-4. Turn knob and remove
service door (A).
2. Unscrew bolt (B) and remove air filter
cover (C).
3. Wash filter (D) in soapy water. Squeeze
dry in clean cloth (DO NOT TWIST).
4. Clean air filter cover before re-installing it.
NOTE: To order a new air filter, contact the
nearest authorized service center at 1-888-
GENERAC (1-888-436-3722).
Figure 4-4. Air Filter Assembly
(000139)
WARNING
Risk of burns. Allow engine to cool before
draining oil or coolant. Failure to do so
could result in death or serious injury.
000804
000116
(000141)
WARNING
Accidental start-up. Disconnect spark plug wires
when working on unit. Failure to do so could result
in death or serious injury.
000822
000666
A
B
A
C
D