Full Product Manual
Table Of Contents
- iQ2000 Portable Generator Owner’s Manual
- Generador portátil iQ2000 Manual del propietario
- Índice
- Sección 1 Introducción y seguridad
- Sección2 Información general y configuración
- Conozca su generador
- Información sobre emisiones
- Enchufes de conexión
- PowerDial
- PowerBar (Barra de potencia)
- Interruptor de economía
- Luces de estado del generador
- Indicador de tiempo de funcionamiento
- Sensor de combustible y medidor de combustible
- Retiro del contenido de la caja
- Cómo añadir aceite de motor
- Combustible
- Sección 3 Operación
- Preguntas sobre funcionamiento y uso
- Antes de poner en marcha el motor
- Preparación del generador para el uso
- Conexión a tierra del generador cuando se usa como unidad portátil
- Conozca los límites del generador
- Transporte e inclinación de la unidad
- Puesta en marcha de motores con arranque con tirador
- Volver poner en marcha motores calientes
- Sistema de parada por nivel de aceite bajo
- Funcionamiento en paralelo
- Sección 4 Mantenimiento y resolución de problemas
- Pieza núm. 0L5110
- Générateur portatif iQ2000 Manuel de l'utilisateur
- Table des matières
- Section 1 Introduction et sécurité
- Section 2 Renseignements généraux et installation
- Connaître le générateur
- Renseignements relatifs aux émissions
- Fiches de branchement
- PowerDial
- Barre d'alimentation
- Commutateur Économie
- Voyants d'état du générateur
- Affichage du temps de fonctionnement
- Capteur de niveau de carburant et jauge de carburant
- Ouverture de la boîte de l'appareil
- Ajoutez de l'huile à moteur
- Carburant
- Section 3 Fonctionnement
- Utilisation et questions liées à l'utilisation
- Avant le démarrage du moteur
- Préparation du générateur avant l'utilisation
- Mise à la terre du générateur lorsque celui-ci est utilisé de manière portative
- Connaître les limites du générateur
- Transport et inclinaison de l'appareil
- Démarrage du moteur à démarrage manuel
- Redémarrage d'un moteur chaud
- Système d'arrêt en cas de niveau d'huile bas
- Fonctionnement en parallèle
- Section 4 Entretien et dépannage
- Pièce No 0L5110

Owner’s Manual for Portable Generator 15
It is recommended to start and run the genera-
tor for 30 minutes, every 30 days. If this is not
possible, refer to the following list to prepare
unit for storage.
• DO NOT place a storage cover on a hot
generator. Allow unit to cool to room tem-
perature before storage.
• DO NOT store fuel from one season to
another unless properly treated.
• Replace fuel container if rust is present.
Rust in fuel will cause fuel system prob-
lems.
• Cover unit with a suitable protective, mois-
ture resistant cover.
• Store unit in a clean, dry area.
• Always store generator and fuel away from
heat and ignition sources.
Prepare Fuel System/Engine for
Storage
Fuel stored over 30 days can go bad and
damage fuel system components. Keep fuel
fresh, use fuel stabilizer.
If fuel stabilizer is added to fuel system, pre-
pare and run engine for long term storage.
Run engine for 10-15 minutes to circulate sta-
bilizer throughout fuel system. Adequately
prepared fuel can be stored up to 24 months.
NOTE: If fuel has not been treated with fuel
stabilizer, it must be drained into an approved
container. Run engine until it stops from lack
of fuel. Use of fuel stabilizer in fuel storage
container is recommended to keep fuel fresh.
1. Change engine oil.
2. Remove spark plug.
3. Pour tablespoon (5-10cc) of clean engine
oil or spray a suitable fogging agent into
cylinder.
4. Pull starter recoil several times to distrib-
ute oil in cylinder.
5. Install spark plug.
6. Pull recoil slowly until resistance is felt.
This will close valves so moisture cannot
enter engine cylinder. Gently release
recoil.
Change Oil
Change engine oil before storage. See,
Change Engine Oil.
(000181)
WARNING
Vision Loss. Eye protection is required to avoid
spray from spark plug hole when cranking engine.
Failure to do so could result in vision loss.