User Manual

General Information and Setup
6 Owner’s Manual for Power Washer
Spray Gun
Become familiar with spray gun trigger and
locking system prior to use.
1. See Figure 2-13. With unit OFF, hold spray
gun and squeeze trigger to learn how
trigger mechanism and locking system can
be activated and deactivated.
Figure 2-13. Spray Gun (typical)
2. Turn ON the water, and squeeze the
trigger to purge the pump system of air.
3. Verify spray gun is OFF with lock engaged
before starting power washer.
Detergent Tank (if equipped)
Power washer is shipped with siphoning tube
and cap.
1. See Figure 2-14. Insert siphoning tube
through hole in cap.
Figure 2-14. Siphoning Tube and Cap
2. Insert siphoning tube into detergent and
snap siphoning tube cap onto detergent
tank.
Nozzles
1. Select correct nozzle for task.
2. See Figure 2-15. Pull back quick–connect
collar and install nozzle.
3. Release quick-connect collar to secure
nozzle.
4. Verify nozzle is locked in place.
Figure 2-15. Insert Nozzle
Blast Pressure Nozzle (Red)
MAXIMUM - Higher pressure and lower flow
for stubborn or hard to reach surface such as
second story surfaces, paint removal, oil
stains, rust removal or other stubborn
substances (tar, gum, grease, wax, etc.).
Clean Pressure Nozzle (Green)
GENERAL - Medium pressure and medium
flow for most all purpose cleaning such as
home siding, brick patios, wood decks,
driveways and sidewalks, garage floors, etc.
Wash Pressure Nozzle (White)
DELICATE - Lower pressure and higher flow
for gentle cleaning of cars/trucks, boats, RV’s,
patio furniture, lawn equipment, etc.
Detergent Nozzle (Black)
DETERGENT ONLY (BLACK), Only use
power washer safe detergents/soaps to help
break down stubborn dirt and grime on a
variety of surfaces.
000123
001487
000125
001396
001398
001399
001400