Operating Guide
Table Of Contents
- iQ3500 Portable Generator Owner’s Manual
- Generador portátil iQ3500 Manual del usuario
- Índice de contenidos
- Sección 1 Introducción y seguridad
- Sección 2 Información general y configuración
- Conozca su generador
- Emisiones
- Enchufes de conexión
- Contador de pantalla digital
- Interruptor de apagado/ encendido/cebado
- Salidas USB
- Interruptor de ahorro
- Luces de estado del generador
- Protectores del circuito
- Retiro del contenido de la caja
- Conexión del cable de la batería (si se incluye)
- Añadir aceite de motor
- Combustible
- Sección 3 Funcionamiento
- Preguntas sobre uso y funcionamiento
- Antes de arrancar el motor
- Preparación del generador para su uso
- Conexión a tierra del generador cuando se utiliza
- Conozca los límites del generador
- Transporte/inclinación de la unidad
- Arranque de motores con el tirador de arranque
- Arranque de motores con arranque eléctrico
- Volver a arrancar motores calientes
- Sistema de cierre por nivel bajo de aceite
- Funcionamiento en paralelo
- Sección 4 Mantenimiento y solución de problemas
- Pieza Nº 10000033207
- Générateur portatif iQ3500 Manuel du propriétaire
- Table des matières
- Section 1 Introduction et règles de sécurité
- Section 2 Informations générales et installation
- Connaître son générateur
- Émissions
- Fiches de raccordement
- Compteur à affichage numérique
- Commutateur de mise à l’arrêt/ mise en marche/commande d’étrangleur
- Ports USB
- Commutateur de fonctionnement au ralenti
- Témoins d'état du générateur
- Dispositifs de protection de circuits
- Retrait des pièces du colis
- Raccordement des câbles de batterie (le cas échéant)
- Ajout d’huile moteur
- Carburant
- Section 3 Fonctionnement
- Questions relatives au fonctionnement
- Avant de démarrer le moteur
- Préparation du générateur à l’utilisation
- Mise à la terre du générateur une fois en fonctionnement
- Connaître les limites de son générateur
- Transport/Inclinaison de l’appareil
- Démarrage des moteurs à démarrage manuel
- Démarrage des moteurs à démarrage électrique
- Démarrage des moteurs à chaud
- Système d’arrêt en cas de faible niveau d’huile
- Fonctionnement en parallèle
- Section 4 Maintenance et dépannage
- Réf. 10000033207
12 Owner’s Manual for Portable Generator
NOTE: If engine fires, but does not continue to
run, rotate the Off/On/Choke dial to OFF and
repeat starting instructions.
IMPORTANT NOTE: Do not overload gener-
ator or individual panel receptacles. See
Figure 3-3. If an overload occurs, the over-
load LED (A) will illuminate and AC output
ceases. To correct, see Generator Status
Lights. Read Know Generator Limits care-
fully.
.
Figure 3-3.Shutdown Fault
Starting Electric Start Engines
1. Unplug all electrical loads from the unit’s
receptacles before starting the engine.
2. Place generator on a level surface.
3. See Figure 3-2. Rotate the Off/On/Choke
switch to CHOKE (1).
4. Switch Economy switch to OFF.
5. Push and hold Off/On switch in the ON
position. See Figure 3-4 (A). Release
switch when engine starts.
Figure 3-4.Push and Hold Off/On Switch
6. See Figure 3-2. When engine starts, rotate
Off/On/Choke dial to ON (2). Choke oper-
ation is reduced as Off/On/Choke dial is
rotated towards ON.
NOTE: If engine fires, but does not continue to
run, rotate the Off/On/Choke dial to OFF and
repeat starting instructions.
Generator Shut Down
1. Shut off all loads and unplug electrical
loads from generator panel receptacles.
2. Let engine run at no-load for several min-
utes to stabilize internal temperatures of
engine and generator.
3. See Figure 3-2 Rotate Off/On/Choke dial
to OFF (3).
4. Turn fuel cap OFF.
Starting Hot Engines
1. See Figure 3-2. Turn Off/On/Choke dial
from STOP to ON. This will open the fuel
valve and permit starting.
2. Firmly grasp recoil handle and pull slowly
until increased resistance is felt. Pull rap-
idly up and away.
Low Oil Level Shutdown System
The engine is equipped with a low oil level
sensor that shuts down the engine automati-
cally when the oil level drops below a speci-
fied level to prevent engine damage. See
Figure 3-3 (B). The engine will not run until the
oil has been filled to the proper level.
If the engine shuts down and there is sufficient
fuel, check engine oil level.
Parallel Operation
See the Parallel Kit Operator’s Manual or con-
tact an IASD.
NOTE: All connections to the parallel kit
should be made while both inverters are
turned off and all loads disconnected.
1. Make sure the Engine Economy Switch is
in the same position on both generators.
2. Make appropriate parallel connections to
the outlets on each Generac inverter as
outlined in the owner’s manual supplied
with the kit.
NOTE: Do not disconnect any parallel kit con-
nections once the units are running.
3. Start both units per starting instructions.
Once the green output indicator illumi-
nates, devices can be connected and
turned on using the parallel kit outlet.
4. Follow Generator Shut Down instructions.
NOTE: Only use Generac approved parallel
kit.
OVERLOAD OUT
PU
T
AB
005483
(000136)
CAUTION
Equipment and property damage. Disconnect electrical
loads prior to starting or stopping unit. Failure to do so
could result in equipment and property damage.
FAULT OUTPUT
M
A
007846
(000136)
CAUTION
Equipment and property damage. Disconnect electrical
loads prior to starting or stopping unit. Failure to do so
could result in equipment and property damage.
(000136)
CAUTION
Equipment and property damage. Disconnect electrical
loads prior to starting or stopping unit. Failure to do so
could result in equipment and property damage.