Product Manual
Table Of Contents
- Introduction
- Table of Contents
- Safety Notes
- Operating Safety
- Engine Safety
- Service Safety
- Towing Safety
- Reporting Trailer Safety Defects
- Safety Symbol Summary
- Specifications - MLT4150MV, MLT4200IV
- Specifications - MLT4200IVCAN
- Unit Dimensions
- Unit Serial Number Locations
- Component Locations
- Light Tower Set Up
- Raising the Mast
- Main Control Panel
- Prestart Checklist
- Emergency Stop Switch
- Starting the Unit
- Automatic Shutdown
- Light Operation
- Voltage Regulation
- Derating for Altitude
- Wet Stacking
- Receptacle Panel
- Shutting Down the Unit
- Lowering the Mast
- Removing the Lights for Transportation
- Towing the Unit
- Lifting the Unit
- General Maintenance
- Basic Maintenance Schedule - Mitsubishi Engine
- Basic Maintenance Schedule - Isuzu Engine
- Winch Use, Operation & Maintenance
- Jack Maintenance
- Trailer Wheel Bearings
- Lower Radiator Hose Heater Option - Use and Maintenance
- Troubleshooting the Lights
- Mast Light Connections
- AC Wiring Diagram
- AC Wiring Diagram - Receptacle Panel
- AC Wiring Diagram - Receptacle Panel Options (1 of 2)
- AC Wiring Diagram - Receptacle Panel Options (2 of 2)
- DC Wiring Diagram
- DC Wiring Diagram - Electric Winch
- DC Wiring Diagrams for Optional Equipment
- Trailer Lights Wiring Diagram
- Service Log
16
MAIN CONTROL PANEL
12 3
5
4
6
7
8
I
O
I
O
I
O
I
O
ON ON ON ON
TURN
MAIN
BREAKER
OFF
MAIN
BREAKER
240V
BALLAST INDICATOR LIGHTS
GLOW
PLUG
INDICATOR
DC
BREAKER
GLOW
PLUG
OFF
RUN
START
NEUTRAL BONDED TO FRAME
ON
ON
LIGHT SWITCHES
00167
1. CIRCUIT BREAKER INDICATOR LIGHT: This light indicates that the main circuit breaker must be opened
(switched off) before starting the engine.
2. MAIN CIRCUIT BREAKER: This 240V (70A or 100A) breaker will disconnect power to the lights and receptacles.
3. LIGHT SWITCHES: One circuit breaker is supplied for each light.
4. BALLAST INDICATOR LIGHTS: Indicates power from the ballast to each light.
5. ENGINE START SWITCH: Keyed switch operates glow plugs, starts and stops engine.
6. GLOW PLUG INDICATOR: Indicates operation of the engine glow plugs. (Mitsubishi engines only.)
7. ENGINE HOUR METER: Keeps track of engine hours for service.
8. DC BREAKER: Circuit breaker (10A) for the engine electrical system.