Product Manual
Table Of Contents
- Section 1: Introduction and Safety
- Section 2: General Information
- Section 3: Operation
- Unit Setup
- Raising the Mast—Manual Winch
- Raising the Mast—Electric Winch (If Equipped)
- Raising the Mast—Power Zone- DLA (If Equipped)
- Prestart Checklist
- Starting the Unit (Key Switch Models)
- Preparing for Start-Up (Power Zone–DLA)
- Manually Starting the Unit
- Light Operation (Key Switch Models)
- Light Operation (Power Zone– DLA) (If Equipped)
- Engine Derating
- Wet Stacking
- Dusk to Dawn Sensor (Power Zone–DLA) (If Equipped)
- Customer Convenience Receptacles
- Shutting Down the Unit
- Shutting Down the Unit (Power Zone–DLA) (If Equipped)
- Lowering the Mast—Manual Winch
- Lowering the Mast—Electric Winch (If Equipped)
- Lowering the Mast—Power Zone- DLA (If Equipped)
- Positive Air Shutdown (PAS) (If Equipped)
- Lower Radiator Hose Heater (If Equipped)
- Tandem Tow (If Equipped)
- Telemetry (If Equipped)
- Spark Arrester (If Equipped)
- Heated Fuel Filter (If Equipped)
- Towing the Unit
- Lifting the Unit
- Tying Down the Unit
- Section 4: Maintenance
- Section 5: Troubleshooting
- Section 6: Wiring Diagrams
- Mast Junction Box Wiring and Light Connections
- AC Wiring—MLT6SKDS
- AC Wiring—MLT6SMDS
- AC Wiring—MLT6SMDS With Power Zone (If Equipped)
- AC Wiring—MLT6SKDS With Power Zone (If Equipped)
- DC Wiring—MLT6SMDS
- DC Wiring—MLT6SMDS With Power Zone (If Equipped)
- DC Wiring—MLT6SKDS
- DC Wiring—MLT6SKDS with Power Zone (If Equipped)
- DC Wiring—Heated Fuel Filter (If Equipped)—MLT6SMDS
- DC Wiring—Heated Fuel Filter (If Equipped)—MLT6SKDS
- DC Wiring—Electric Winch (If Equipped) with Standard Controller
- Trailer Lights
- DC Wiring—Electric Winch with Power Zone Controller (If Equipped)
Owner’s Manual for Mobile Light Tower 11
General Information
Place Trailer Tongue in Storage Position
1. Verify unit is on a level surface and wheels are
blocked.
2. See Figure 2-7. Extend jack (A) enough to allow
minimum effort to pivot trailer tongue into storage
position.
Figure 2-7. Extend Jack and Remove Pins
3. Remove pins (B) and (C) from trailer tongue.
4. See Figure 2-8. Pivot trailer tongue into storage
position.
NOTE: Varying levels of effort may be required
depending on terrain.
Figure 2-8. Pivot Trailer Tongue Into Storage Position
5. See Figure 2-9. Install pins (B) and (C) at locations
shown to secure trailer tongue in storage position.
Figure 2-9. Install Pins and Rotate Jack
6. Remove clevis and remove jack (A) from tongue
weldment.
7. Completely retract jack.
8. Rotate jack 90° counterclockwise, place jack on
tongue weldment, and install clevis to secure jack
parallel to ground.
003593
C
B
A
CAUTION
(000313)
Pinching and crushing hazard. To avoid
possible injury, keep fingers away from pivot
point when folding or unfolding trailer tongue.
003520
003591
C
B
A