Product Manual
Table Of Contents
- Section 1: Introduction and Safety
- Section 2: General Information
- Section 3: Operation
- Unit Setup
- Raising the Mast—Manual Winch
- Raising the Mast—Electric Winch (If Equipped)
- Raising the Mast—Power Zone- DLA (If Equipped)
- Prestart Checklist
- Starting the Unit (Key Switch Models)
- Preparing for Start-Up (Power Zone–DLA)
- Manually Starting the Unit
- Light Operation (Key Switch Models)
- Light Operation (Power Zone– DLA) (If Equipped)
- Engine Derating
- Wet Stacking
- Dusk to Dawn Sensor (Power Zone–DLA) (If Equipped)
- Customer Convenience Receptacles
- Shutting Down the Unit
- Shutting Down the Unit (Power Zone–DLA) (If Equipped)
- Lowering the Mast—Manual Winch
- Lowering the Mast—Electric Winch (If Equipped)
- Lowering the Mast—Power Zone- DLA (If Equipped)
- Positive Air Shutdown (PAS) (If Equipped)
- Lower Radiator Hose Heater (If Equipped)
- Tandem Tow (If Equipped)
- Telemetry (If Equipped)
- Spark Arrester (If Equipped)
- Heated Fuel Filter (If Equipped)
- Towing the Unit
- Lifting the Unit
- Tying Down the Unit
- Section 4: Maintenance
- Section 5: Troubleshooting
- Section 6: Wiring Diagrams
- Mast Junction Box Wiring and Light Connections
- AC Wiring—MLT6SKDS
- AC Wiring—MLT6SMDS
- AC Wiring—MLT6SMDS With Power Zone (If Equipped)
- AC Wiring—MLT6SKDS With Power Zone (If Equipped)
- DC Wiring—MLT6SMDS
- DC Wiring—MLT6SMDS With Power Zone (If Equipped)
- DC Wiring—MLT6SKDS
- DC Wiring—MLT6SKDS with Power Zone (If Equipped)
- DC Wiring—Heated Fuel Filter (If Equipped)—MLT6SMDS
- DC Wiring—Heated Fuel Filter (If Equipped)—MLT6SKDS
- DC Wiring—Electric Winch (If Equipped) with Standard Controller
- Trailer Lights
- DC Wiring—Electric Winch with Power Zone Controller (If Equipped)
Owner’s Manual for Mobile Light Tower 15
General Information
Operator Screens
See Figure 2-13. The operator screens display the most
relevant and critical information needed to properly
configure and use the unit. From these six screens, the
operator can access information necessary to operate
the unit under normal conditions.
Figure 2-13. Operator Screens Location
Home Screen
See Figure 2-14. The Home screen is the default screen
of the controller and displays after the controller is
powered up and the unit management software is
loaded. It displays the controller mode, total operating
hours, hours left until the next service interval, engine
operating status, and engine rpm. If the unit is in AUTO
mode, the Home screen may also display whether the
scheduler or “dusk to dawn” is enabled.
Figure 2-14. Home Screen
Mast Operation Screen
See Figure 2-15. Allows the operator to raise or lower
the mast.
Figure 2-15. Mast Operation Screen
Battery Voltage Screen
See Figure 2-16. Displays engine battery voltage. A
normal reading is 12-14V on 12 volt systems (with engine
running).
Figure 2-16. Battery Voltage Screen
002354
002544
004765
002990