Product Manual
Table Of Contents
- Section 1: Introduction and Safety
- Section 2: General Information
- Section 3: Operation
- Unit Setup
- Raising the Mast—Manual Winch
- Raising the Mast—Electric Winch (If Equipped)
- Raising the Mast—Power Zone- DLA (If Equipped)
- Prestart Checklist
- Starting the Unit (Key Switch Models)
- Preparing for Start-Up (Power Zone–DLA)
- Manually Starting the Unit
- Light Operation (Key Switch Models)
- Light Operation (Power Zone– DLA) (If Equipped)
- Engine Derating
- Wet Stacking
- Dusk to Dawn Sensor (Power Zone–DLA) (If Equipped)
- Customer Convenience Receptacles
- Shutting Down the Unit
- Shutting Down the Unit (Power Zone–DLA) (If Equipped)
- Lowering the Mast—Manual Winch
- Lowering the Mast—Electric Winch (If Equipped)
- Lowering the Mast—Power Zone- DLA (If Equipped)
- Positive Air Shutdown (PAS) (If Equipped)
- Lower Radiator Hose Heater (If Equipped)
- Tandem Tow (If Equipped)
- Telemetry (If Equipped)
- Spark Arrester (If Equipped)
- Heated Fuel Filter (If Equipped)
- Towing the Unit
- Lifting the Unit
- Tying Down the Unit
- Section 4: Maintenance
- Section 5: Troubleshooting
- Section 6: Wiring Diagrams
- Mast Junction Box Wiring and Light Connections
- AC Wiring—MLT6SKDS
- AC Wiring—MLT6SMDS
- AC Wiring—MLT6SMDS With Power Zone (If Equipped)
- AC Wiring—MLT6SKDS With Power Zone (If Equipped)
- DC Wiring—MLT6SMDS
- DC Wiring—MLT6SMDS With Power Zone (If Equipped)
- DC Wiring—MLT6SKDS
- DC Wiring—MLT6SKDS with Power Zone (If Equipped)
- DC Wiring—Heated Fuel Filter (If Equipped)—MLT6SMDS
- DC Wiring—Heated Fuel Filter (If Equipped)—MLT6SKDS
- DC Wiring—Electric Winch (If Equipped) with Standard Controller
- Trailer Lights
- DC Wiring—Electric Winch with Power Zone Controller (If Equipped)
16 Owner’s Manual for Mobile Light Tower
General Information
Lights Screen
See Figure 2-17. Allows the operator to turn the lights on
and off. Refer to Light Operation (Key Switch Models)
for more information.
Figure 2-17. Lights Screen
Line Amperage Screen
See Figure 2-18. The Line Amperage screen displays
the AC output amperage produced by the generator in
amps (A). The load balance for each line (L1 and L3) is
displayed in both numerical and graphical form. It is
important to maintain a balanced load distribution
between lines for optimum generator performance.
Figure 2-18. Line Amperage Screen
Generator Screen
See Figure 2-19. The Generator screen displays the
average line voltage, frequency (in Hertz), and power
factor for the generator while in operation.
Figure 2-19. Generator Screen
Dusk to Dawn Screen
NOTE: This feature only works in AUTO mode.
See Figure 2-20. The Dusk to Dawn screen enables or
disables the “dusk to dawn” function. This function uses a
photo sensor to detect the surrounding light level,
automatically starting the engine and turning the lights on
at dusk. The engine will run and the lights will remain
illuminated until dawn.
Figure 2-20. Dusk to Dawn Screen
Scheduler Screen
NOTE: This feature will only work in AUTO mode.
002327
002980
002981
002328