Product Manual
Table Of Contents
- Section 1: Introduction and Safety
- Section 2: General Information
- Section 3: Operation
- Unit Setup
- Raising the Mast—Manual Winch
- Raising the Mast—Electric Winch (If Equipped)
- Raising the Mast—Power Zone- DLA (If Equipped)
- Prestart Checklist
- Starting the Unit (Key Switch Models)
- Preparing for Start-Up (Power Zone–DLA)
- Manually Starting the Unit
- Light Operation (Key Switch Models)
- Light Operation (Power Zone– DLA) (If Equipped)
- Engine Derating
- Wet Stacking
- Dusk to Dawn Sensor (Power Zone–DLA) (If Equipped)
- Customer Convenience Receptacles
- Shutting Down the Unit
- Shutting Down the Unit (Power Zone–DLA) (If Equipped)
- Lowering the Mast—Manual Winch
- Lowering the Mast—Electric Winch (If Equipped)
- Lowering the Mast—Power Zone- DLA (If Equipped)
- Positive Air Shutdown (PAS) (If Equipped)
- Lower Radiator Hose Heater (If Equipped)
- Tandem Tow (If Equipped)
- Telemetry (If Equipped)
- Spark Arrester (If Equipped)
- Heated Fuel Filter (If Equipped)
- Towing the Unit
- Lifting the Unit
- Tying Down the Unit
- Section 4: Maintenance
- Section 5: Troubleshooting
- Section 6: Wiring Diagrams
- Mast Junction Box Wiring and Light Connections
- AC Wiring—MLT6SKDS
- AC Wiring—MLT6SMDS
- AC Wiring—MLT6SMDS With Power Zone (If Equipped)
- AC Wiring—MLT6SKDS With Power Zone (If Equipped)
- DC Wiring—MLT6SMDS
- DC Wiring—MLT6SMDS With Power Zone (If Equipped)
- DC Wiring—MLT6SKDS
- DC Wiring—MLT6SKDS with Power Zone (If Equipped)
- DC Wiring—Heated Fuel Filter (If Equipped)—MLT6SMDS
- DC Wiring—Heated Fuel Filter (If Equipped)—MLT6SKDS
- DC Wiring—Electric Winch (If Equipped) with Standard Controller
- Trailer Lights
- DC Wiring—Electric Winch with Power Zone Controller (If Equipped)
26 Owner’s Manual for Mobile Light Tower
Operation
3. See Figure 3-8. Turn the key to the right START
position and hold it (10 seconds maximum) until
the engine cranks and starts running.
Figure 3-8. Crank Engine
IMPORTANT NOTE: Do not crank engine for more
than 10 seconds.
4. See Figure 3-9. Release the key, it will move to the
RUN position.
Figure 3-9. Release Key
IMPORTANT NOTE: If unit does not start after 10
seconds of cranking, turn key to STOP position and
wait 30 seconds. Then, repeat steps 2–3 as neces-
sary.
Preparing for Start-Up (Power
Zone–DLA)
NOTE: If the engine was run out of fuel or the fuel tank
was drained, it may be necessary to purge the fuel lines
before starting. Refer to the engine manual supplied with
the unit.
Select AUTO or MANUAL Mode
See Figure 3-10. Use the select button to select AUTO
or MANUAL on the Home screen.
• AUTO mode is required for programming auto-
matic start and stop times (see Scheduler
Screen), or enabling the “dusk to dawn” sensor
(see Dusk to Dawn Sensor (Power Zone–DLA)
(If Equipped)).
• MANUAL mode is used for on-demand control of
the lights and convenience receptacles.
009952
009953