Product Manual
Table Of Contents
- Section 1: Introduction and Safety
- Section 2: General Information
- Section 3: Operation
- Unit Setup
- Raising the Mast—Manual Winch
- Raising the Mast—Electric Winch (If Equipped)
- Prestart Checklist
- Starting Unit—Analog Controls
- Starting Unit—Power Zone Controls (MANUAL Mode)
- Starting Unit—Power Zone Controls (AUTO Mode)
- Operating Lights—Analog Controls
- Operating Lights—Power Zone Controls (MANUAL Mode)
- Operating Lights—Power Zone Controls (AUTO Mode)
- Shutting Down Unit—Analog Controls
- Shutting Down Unit—Power Zone Controls (MANUAL Mode)
- Shutting Down Unit—Power Zone Controls (AUTO Mode)
- Automatic Shutdown
- Starting Utility Mode (If Equipped)—Analog Controls
- Starting Utility Mode (If Equipped—Power Zone Controls
- Stopping Utility Mode (If Equipped)—Analog Controls
- Stopping Utility Mode (If Equipped)—Power Zone Controls
- Dusk-to-Dawn Sensor (If Equipped)
- Customer Convenience Receptacles (If Equipped)
- Removing Loads from Receptacles (If Equipped)
- Storing the Unit
- Lowering the Mast—Manual Winch
- Lowering the Mast—Electric Winch (If Equipped)
- Positive Air Shutdown (PAS) (If Equipped)
- Lower Radiator Hose Heater (If Equipped)
- Tandem Tow (If Equipped)
- Telemetry (If Equipped)
- Spark Arrester (If Equipped)
- Heated Fuel Filter (If Equipped)
- Towing the Unit
- Lifting the Unit
- Tying Down the Unit
- Section 4: Maintenance
- Section 5: Troubleshooting
- Section 6: Wiring Diagrams
Owner’s Manual for Mobile Light Tower 27
Operation
6. See Figure 3-7. Turn ignition switch to GLOW
PLUG position and hold for 10 to 15 seconds
Figure 3-7. Activate Glow Plug
IMPORTANT NOTE: Do not hold ignition switch in
GLOW PLUG position for more than 15 seconds.
7. See Figure 3-8. Turn ignition switch to START
position and hold (10 seconds maximum) until
engine cranks and starts.
Figure 3-8. Crank Engine
IMPORTANT NOTE: Do not crank engine for more
than 10 seconds.
8. See Figure 3-9. Release ignition switch. It moves
to the RUN position.
Figure 3-9. Release Key
IMPORTANT NOTE: If unit does not start after 10
seconds of cranking, turn ignition switch to STOP
position and wait 30 seconds. Then, repeat steps 6–7
as necessary.
9. Begin using lights and receptacles (if equipped), in
accordance with the following:
• To operate lights, see Operating Lights—Analog
Controls.
• To operate 120 V convenience receptacles, see
Customer Convenience Receptacles (If
Equipped).
Starting Unit—Power Zone
Controls (MANUAL Mode)
NOTE: If the engine was run out of fuel or the fuel tank
was drained, it may be necessary to purge the fuel lines
before starting. See the OEM engine manual supplied
with the unit.
1. Open unit hood.
2. See Figure 3-10. Switch the flex switch (if
equipped) to position 2.
Figure 3-10. Flex Switch—Position 2
3. Close unit hood.
4. See Figure 3-11. Switch controller power to ON (I).
Figure 3-11. Controller Power ON (I)
5. See Figure 3-12. Press the START-STOP button.
Wait for engine to start.
Figure 3-12. Engine START-STOP Button
009951
009952
009953
010585
010588
010582
A
B
C