Product Manual
Table Of Contents
- Section 1: Introduction and Safety
- Section 2: General Information
- Section 3: Operation
- Unit Setup
- Raising the Mast—Manual Winch
- Raising the Mast—Electric Winch (If Equipped)
- Prestart Checklist
- Starting Unit—Analog Controls
- Starting Unit—Power Zone Controls (MANUAL Mode)
- Starting Unit—Power Zone Controls (AUTO Mode)
- Operating Lights—Analog Controls
- Operating Lights—Power Zone Controls (MANUAL Mode)
- Operating Lights—Power Zone Controls (AUTO Mode)
- Shutting Down Unit—Analog Controls
- Shutting Down Unit—Power Zone Controls (MANUAL Mode)
- Shutting Down Unit—Power Zone Controls (AUTO Mode)
- Automatic Shutdown
- Starting Utility Mode (If Equipped)—Analog Controls
- Starting Utility Mode (If Equipped—Power Zone Controls
- Stopping Utility Mode (If Equipped)—Analog Controls
- Stopping Utility Mode (If Equipped)—Power Zone Controls
- Dusk-to-Dawn Sensor (If Equipped)
- Customer Convenience Receptacles (If Equipped)
- Removing Loads from Receptacles (If Equipped)
- Storing the Unit
- Lowering the Mast—Manual Winch
- Lowering the Mast—Electric Winch (If Equipped)
- Positive Air Shutdown (PAS) (If Equipped)
- Lower Radiator Hose Heater (If Equipped)
- Tandem Tow (If Equipped)
- Telemetry (If Equipped)
- Spark Arrester (If Equipped)
- Heated Fuel Filter (If Equipped)
- Towing the Unit
- Lifting the Unit
- Tying Down the Unit
- Section 4: Maintenance
- Section 5: Troubleshooting
- Section 6: Wiring Diagrams
Owner’s Manual for Mobile Light Tower 29
Operation
Operating Lights—Analog
Controls
1. Verify the unit is ON and running smoothly. See
Starting Unit—Analog Controls.
2. See Figure 3-16. Switch main circuit breaker to
ON (I).
Figure 3-16. Main Circuit Breaker ON (I)
3. See Figure 3-17. Switch lights to ON (I).
Figure 3-17. Lights ON (I)
Operating Lights—Power Zone
Controls (MANUAL Mode)
1. Verify the unit is ON and running smoothly. See
Starting Unit—Power Zone Controls (MANUAL
Mode).
2. Switch main circuit breaker to ON (I).
3. See Figure 3-18. Press one or more light ON-OFF
buttons.
Figure 3-18. Light Fixture ON-OFF Buttons
NOTE: If the main circuit breaker is OFF, the light fixture
ON-OFF button LED (A) illuminates but the light fixture
does not. Switch main circuit breaker ON.
Figure 3-19. Light Fixture ON-OFF Button
Operating Lights—Power Zone
Controls (AUTO Mode)
In AUTO mode, light fixtures automatically switch ON,
according to the active schedule. Change which lights
switch ON by pressing one or more light ON-OFF buttons
(Figure 3-18).
010589
MAIN AC
CIRCUIT
BREAKER
010590
Light 1
Light 2
Light 4
Light 3
010579
010591
A