Product Manual
Table Of Contents
- Section 1: Introduction and Safety
- Section 2: General Information
- Section 3: Operation
- Unit Setup
- Raising the Mast—Manual Winch
- Raising the Mast—Electric Winch (If Equipped)
- Prestart Checklist
- Starting Unit—Analog Controls
- Starting Unit—Power Zone Controls (MANUAL Mode)
- Starting Unit—Power Zone Controls (AUTO Mode)
- Operating Lights—Analog Controls
- Operating Lights—Power Zone Controls (MANUAL Mode)
- Operating Lights—Power Zone Controls (AUTO Mode)
- Shutting Down Unit—Analog Controls
- Shutting Down Unit—Power Zone Controls (MANUAL Mode)
- Shutting Down Unit—Power Zone Controls (AUTO Mode)
- Automatic Shutdown
- Starting Utility Mode (If Equipped)—Analog Controls
- Starting Utility Mode (If Equipped—Power Zone Controls
- Stopping Utility Mode (If Equipped)—Analog Controls
- Stopping Utility Mode (If Equipped)—Power Zone Controls
- Dusk-to-Dawn Sensor (If Equipped)
- Customer Convenience Receptacles (If Equipped)
- Removing Loads from Receptacles (If Equipped)
- Storing the Unit
- Lowering the Mast—Manual Winch
- Lowering the Mast—Electric Winch (If Equipped)
- Positive Air Shutdown (PAS) (If Equipped)
- Lower Radiator Hose Heater (If Equipped)
- Tandem Tow (If Equipped)
- Telemetry (If Equipped)
- Spark Arrester (If Equipped)
- Heated Fuel Filter (If Equipped)
- Towing the Unit
- Lifting the Unit
- Tying Down the Unit
- Section 4: Maintenance
- Section 5: Troubleshooting
- Section 6: Wiring Diagrams
Owner’s Manual for Mobile Light Tower 35
Operation
7. See Figure 3-56. Switch the flex switch (if
equipped) to position 0.
Figure 3-56. Flex Switch—Position 0
8. See Figure 3-57. Remove 240 V, four-terminal
cord from unit power inlet port.
Figure 3-57. Utility Cord Removal from Unit
9. Close unit hood.
Dusk-to-Dawn Sensor (If
Equipped)
See Figure 3-58. Units equipped with Power Zone
Autolight controller are also equipped with a dusk-to-
dawn sensor (A), which senses light and accordingly
starts and stops the unit.
The sensor’s perception of dusk and dawn can be
adjusted, due to an adjustable light-shield equipped near
the sensor.
Figure 3-58. Sensor, Shield Located Behind Mast
NOTE: The dusk-to-dawn sensor is only used when the
controller is in AUTO mode and the active schedule is
Dusk to Dawn.
Preparing Sensor for Use
Perform the following procedure at the time of day you
want the lights to switch on.
1. Verify controller is in AUTO mode and the active
schedule is Dusk to Dawn. See Starting Unit—
Power Zone Controls (AUTO Mode).
2. Loosen screws on light shield.
3. Slide the light-shield up, decreasing the sensor’s
exposure to light, until the lights turn on.
4. Tighten screws on light shield.
010595
010599
010600
A