Product Manual

Owner’s Manual for Tow-Behind Field and Brush Mower 9
General Information and Setup
Adding Fuel
1.
Place unit on a level surface in a well ventilated area.
2. Verify unit is OFF and cooled for a minimum of two
minutes.
3. See Figure 2-12. Remove the gas fill cap (A).
Figure 2-12. Fuel Cap
4. Fill tank with fresh, unleaded gas with a minimum
90 octane rating to 0.25 in (6.4 mm) from the bot-
tom of the fill neck to allow for fuel expansion.
5. Install fuel fill cap.
High Altitude Replacement Kit
At high altitude, standard carburetor air-fuel mixture will
be too rich. A rich mixture decreases performance,
increases fuel consumption, fouls the spark plug and
causes hard starting. Operation at high altitude for
extended periods of time, may increase emissions.
Proper operation at higher altitudes can be improved by
installing an altitude kit when required. See Table 2:
High Altitude Replacement Kit
Table 2 – High Altitude Replacement Kit
Kits can be obtained by contacting Generac Customer
Service at 1-888-436-3722 (1-888-GENERAC), or
www.generac.com. Kits must be installed by a qualified
individual.
NOTE: If a
carburetor
is
replaced, the proper high altitude
kit
jet will
need
to be
installed into the replacement
carburetor.
NOTE: The warranty may be void if installation of a
high altitude kit is not made for high altitude use.
Connecting Battery Cable
Units are shipped with the negative terminal battery cable
disconnected. Before use, connect the battery cable.
1. See Figure 2-13. Connect negative cable (A) to
negative (-) battery terminal.
Figure 2-13. Connecting Battery Cable
Checking Tire Pressure
1. See Figure 2-14. Remove valve stem cap (A) and
check tire pressure with a tire pressure gauge.
Figure 2-14. Valve Stem Location
2.
Compare the tire pressure reading with the manufac-
turer’s recommended tire pressure stamped on tire.
3. If pressure is low, add air through the valve stem
with an air hose.
4. Replace the valve stem cap when finished.
Altitude Range Part Number
0-5000 ft Not required
5000-8000 ft 10000035259
(000105)
DANGER
Explosion and Fire. Fuel and vapors are
extremely flammable and explosive. Add fuel
in a well ventilated area. Keep fire and spark
away. Failure to do so will result in death
or serious injury.
(000214)
DANGER
Explosion and Fire. Do not fill fuel tank past full line.
Allow for fuel expansion. Overfilling may cause fuel
to spill onto engine causing fire or explosion, which
will result in death or serious injury.
WARNING
Explosion and Fire. Do not smoke while
refueling unit. Failure to do so could result in
death, serious injury, or property or equipment
damage.
(000284a)
006485
A
A
005874
A
005878
A