Install Instructions

General Filters
Incorporated
29 | P a g e
10.8 Hose Routing and Connections
Connect the steam hose to the stainless elbow fitting located at the bottom of the manifold and secure with the hose
clamp provided. See Figure 3.m. for additional hose routing recommendations. Do not force the steam hose onto the
stainless fitting - apply some water to the inside of the hose and ease the hose onto the fitting. Connect the
condensate hose to the molded barbed fitting on the right. (See Figure 10.g) The condensate hose needs to be
trapped immediately under the blower housing or directly above the steam humidifier using a 6” loop in the condensate
hose.
The 3/8” x 3/8” barbed hose fitting enables the condensate hose to connect to the fill cup. Insert one end of the fitting
into the condensate hose (Figure 10.h.), route the hose into the unit through the hole in the enclosure, and then insert
the other end of the fitting into the hole on the top of the fill cup (Figure 10.i.).
Figure 10.f.
Figure 10.g.
Figure 10.i.
Figure 10.h.