Installation Guide

Node B Installation Guide

Version 5.0.0 Page 19 of 37

Pole Mounting

This section specifies a suggested pole mount scheme using Unistrut components, and

equivalent system can be used where available more readily locally.

The Unistrut system can as standard cater for pole diameters up to 10inch (250mm).

To mount the bracket for a pole the following materials are required:-

1. 2 pieces of P1001Bx14" A2-304 Stainless Steel Unistrut™

2. 4off P1007 - 5/16”-18 UNC channel nuts with springs from Unistrut™ - locally supplied

3. 4off 5/16” x 1” UNC – Hex Head Cap Screw - Unistrut™ PN: HSHS031100EG or

equivalent - locally supplied

4. 4off 5/16” – Plain washer Stainless Steel - Unistrut™ PN: HFLW031EG or equivalent -

locally supplied

5. 4off 5/16” - Lock washer Stainless Steel - Unistrut™ PN: HFKW031EG or equivalent -

locally supplied

6. 2off Cush-A-Clamp Sets (2-6inch) or U-Bolt Series (< 12inch)– see Unistrut™ catalogue

The following diagram illustrates the installation using the Unistrut method:-

Figure 6-7 : Pole Mounting using Unistrut systems

Note

: Where a Node B is required to be mounted to a pole greater than 10inch or to an

irregular shaped mast eg. Hexagonal, banding may required to be used. In this situation

contact your IPWireless field support for guidance.

Node B Bracket

2off - 360mm (14inch)

Dual-Unistrut channel

4off - Unistrut channel

nuts w spring

2off – Unistrut pole mounts

Cush-A-Clamp

U-Bolt Series

5/16” x 1” UNC –

- Hex Head Cap Screw

- Lock Washer

- Plain Washer