Installation Guide

Node B Installation Guide
Version 5.0.0 Page 20 of 37
Rack Mount
This section describes the mounting of the Node B bracket into a rack. The following
mounting materials are required to secure the bracket into a rack. The figure below
illustrates a typical installation, rack not shown.
1. Plate (9U x 19inch shown) or U-channels to mount the bracket onto standard 19" or
23"
2. 4off M8x20 Hex Head Cap Screw + 8off M8 Plain washer + 8off M8 Lock Washer +
4off M8 Nuts
3. 8 off Cage nuts + Screws – note these are required to secure the plate to the rack
(not shown)
Figure 6-8 : Node B - Rack Mounted
Node B Bracket
M8 Fixings –
- Hex Head Cap Screw
- Lock Washer
- Plain Washer 2off
- Nut
19inch 9U Plate