Integration Guide

OEM TD-CDMA PCI Express Module Integration
May 2013 General Dynamics Broadband Proprietary and Confidential Page 18 of 20
Subject to Non Disclosure Agreement
5 Regulatory Information – Model AAU 2.5GHz Band.
NOTE: This module is not suitable for installation in products that are required to meet ATEX or other
Hazardous Location requirements.
5.1 FCC Requirements for North America
5.1.1 Compliance with FCC Rules and Regulations
The General Dynamics Broadband PCI Express Mini module AAU, is certified as a module for mobile
applications against FCC Parts 15 & 27 for operation in the EBS/BRS frequency allocation defined as
2496-2690MHz operating as a Time Division Duplex device.
Band
Uplink (Transmit)
Downlink (Receive)
2.5GHz EBS/BRS
2496 – 2690MHz
2496 – 2690MHz
IMPORTANT: Manufacturers of devices containing the General Dynamics Broadband TD-CDMA PCI
Express Mini module Model AAU are advised to.
1. Clarify any regulatory questions, particularly if the host device contains other radio
transceivers.
2. Have their final product tested and approved for compliance with FCC rules.
3. Include instructions with the final product regarding meeting the RF Exposure requirements of
the FCC rules.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Caution: Changes or modifications not covered in this document must be approved in writing by the
General Dynamics Broadband. Changes or modifications made without written approval may void the
user’s authority to operate this equipment.
5.1.2 FCC Labelling Requirements
This module is certified under FCC ID: PKTPEMAAU2, if the FCC ID on the module label is not visible
from the outside of the host device then an additional label is required on the outside of the host
device.
This label is required to state ‘Contains FCC ID: PKTPEMAAU2’.
5.1.3 Exposure to Radio Frequency Signals
The RF exposure evaluation/compliance of the module is for use in mobile host equipment and the
module should be installed and operated with a minimum separation distance of 20cm between the
antenna and the user, otherwise the host product requires re-approval.
The host equipment manufacturer must supply a user RF exposure warning statement that states a
minimum 20cm usage distance is required from the antenna in order to comply with RF exposure
rules.