External MIMO Antenna for LTE modem USER MANUAL
General Information In order to improve the data transmission parameters, a special external antenna (model: LTE-ODUP001-IPW) has been designed to interwork with the LTE USB-stick modem. The antenna base has a build-in magnet which facilitates the installation on metal surfaces e.g. metal windowsills. With the fixings provided it is also possible to secure the antenna to an internal or external walls. The antenna is equipped with a 3 meter cable terminated with the RF connector for connecting to the modem.
Installation instructions Before connecting to the modem, two antenna arms shall be connected to the base. After attaching the antenna arms, they are positioned at a fixed factory tilt angle (i.e. approx. 45 degrees relative to the base). Insert antenna arm onto base connector Secure arm using knurled connection IPW-2754 Iss.
Installation on the wall Screw the supplied screws into the wall in such a way that the screws match the ‘keyholes’ in the base so that after installation the antenna is fastened in the horizontal position. The screw heads should protrude approximately 1.5mm from the wall. Then the antenna shall be hung up in such a way that its arms are facing the upward direction under the angle as depicted in the picture below.
Connecting the antenna to the modem Before connecting to the modem, move the slider covering the antenna connector at the bottom of the USB modem to the “open” position. Slider open/closed direction Slider closed Slider open Connecting the antenna to the modem is shown in the picture below.Connectors of the antenna cable must be carefully inserted vertically into ports in the enclosure of the modem. Connector insert/extract IPW-2754 Iss.
