User's Manual

IPW-2754 Iss.1 4
Installation on the wall
 Screw the supplied screws into the wall in such a way that the
screws match the ‘keyholes’ in the base so that after
installation the antenna is fastened in the horizontal position.
The screw heads should protrude approximately 1.5mm from
the wall.
 Then the antenna shall be hung up in such a way that its arms
are facing the upward direction under the angle as depicted in
the picture below. Make sure that the screw heads are in the
narrow side of the opening in the base of the antenna
Screw keyholes