User's Manual

99-P42565K 65
Matrix code
R – relay station
O – the unit contacts you via the relay
station (you do not see the unit directly)
M – main relay station (best connected
relay node)
L – transmission from this unit is received
but is below the required reception level
and consequently cannot be part of the
network
N – transmission from this unit is received
but it cannot be part of the network due to
limitations of the network.
Note:
Units displayed by an empty box indicates
that the unit functions normally (not as a
relay) and receives transmissions directly.
When RSSI is set on, the receive signal
parameters are displayed.
The top left digits represent the number of
packets directly received from a possible
last 9 packets window. The top right digit
represents the quality of the link used to
communicate: 3 is the best, 0 is no link.
The character in the middle (L or H)
represents the state of the low noise
amplifier. H - the amplifier is operational, L
- the amplifier is not running, in order to
avoid signal compression when the units
are close to each other.
The lower digits show the Received Signal
Strength value (0 - 750 possible) of the
signal received from this unit.