User's Manual

3-12
Table 3-3. Remote Transceiver Operation Commands (Cont)
CODE NAME DESCRIPTION
EQUIVALENT
TRANSCEIVER
KEYPAD COMMAND
X
Note 1
Text Mode The “X” Command followed by a 0 or 1 will
select between PT (Plain Text, Voice) and CT
(Cipher Text, Data).
"X0" = Plain Text (PT)
"X1" = Cipher Text (CT)
(Returns a NAK if in Aviation Mode)
For transceivers with the EBN-30 and/or the
UPL-100 Option: If the 150Hz Tone Squelch is
activated the transceiver will revert to the Plain
Text (PT) mode only.
5
PT/CT
(See Paragraph 2-3.2.4)
Q Store Function The “Q” Command will store the entered data
in EEPROM for the current preset channel.
STO
(See Paragraph 2-3.2.6)
C Scan list member The “C” Command followed by a 0 or 1 will
select whether the current preset channel is
ON or OFF the Scan List.
"C0" = OFF the scan list
"C1" = ON the scan list
7
SCNLST
SCAN
(See Paragraph 2-3.2.7)
#
Note 1
Power Level Setting The “#” Command followed by a 0, 1, or 2 will
select the transmitter’s output power for the
current preset channel.
"#0" = FM: Lo power, AM: Lo power
"#1" = FM: Med power, AM: Hi power
"#2" = FM: Hi power, AM: Hi power
8
PWR
METER
(See Paragraph 2-3.1.5)
S Scan Mode The “S” Command followed by a 0 or 1 will
place the transceiver in the Scan Mode.
"S0" = Scan Mode Off
"S1" = Scan Mode On
Note, if the scan list has less than two preset
channels, the transceiver will return a "NAK".
Only Inquiry Command ?02 is available during
the scan operation.
6
MODE
7
SCNLST
SCN
(See Paragraph 2-3.3.1)
* Beacon Mode The “*” Command followed by a 0 or 1 will
place the transceiver in the Beacon Mode.
"*0" = Beacon Mode Off,
"*1" = Beacon Mode On
6
BCN
1
FREQ
(See Paragraph 2-3.3.2)