User's Manual

TABLE OF CONTENTS
Paragraph Page
ii
2-3.3.3
............................................................. 2-10 Internal Voltage Measurements
2-3.3.4
............................................................... 2-10 Release from Remote Control
2-4.
................................................................................................... 2-10 ECS-8 8.33 KHZ Option
2-5.
........................................................................................................ 2-11 Operating Procedure
2.5.1
................................................................................................................................. 2-11 Siting
2-5.1.
......................................................................................... 2-11 Unencrypted Operation
2-6.
................................................................................ 2-11 URC-200 (V2) EEPROM Limitations
2-6.1.
............................................................... 2-11 Front Panel User Command Limitations
2-6.1.1
............................................................................ 2-11 Select Scan Channels
2-6.1.2
.......................................................................... 2-11 Cancellation of Presets
2-6.1.3
......................................................................... 2-11 Select Preset Channels
2-6.1.4
....................................................................................... 2-12 Storing Presets
2-6.2.
.......................................................................... 2-12 Alignment Command Limitations
2-6.2.1
.................................................................... 2-12 Warp Alignment Command
2-7.
................................................................................................................ 2-12 Error Messages
SECTION 3.
................................................................................................. 3-1 INSTALLATION
3-1.
............................................................................................................ 3-1 General Information
3-2.
..................................................................................... 3-1 Assembly and Preparation for Use
3-2.1.
.............................................................................. 3-1 Checking Unpacked Equipment
3-2.2.
......................................................................... 3-1 Installing or replacing the Batteries
3-2.3.
..................................................................... 3-2 Attaching and Removing the Handset
3-2.4.
............................................................................................. 3-2 Attaching the Antenna
3-2.4.1
.............................................................................. 3-2 Attaching the Antenna
3-2.4.2
............................................................................ 3-3 Removing the Antenna
3-3.
.............................................................................................................. 3-4 Remote Operation
3-3.1.
.................................................................................. 3-4 Remote Control Interconnect
3-3.1.1
................................................................................... 3-4 X-mode Connector
3-3.1.2
................................................................... 3-4 Data Rates and Logic Levels
3-3.1.3
.......................................................................... 3-5 Data Exchange Protocol
3-3.2.
............................................................................................ 3-6 Remote Control Codes
3-4.
................................................................................................... 3-18 Interface Characteristics
SECTION 4.
................................................................................. 4-1 SYSTEM MAINTENANCE
4-1.
............................................................................................................ 4-1 General Information
4-2.
........................................................................................................... 4-1 Manual System Test
4-2.1.
........................................................................................ 4-1 Test Equipment Required
4-2.2.
........................................................................................................ 4-2 Receiver Tests
4-2.2.1
.............................................................. 4-2 FM PT Sensitivity and Distortion
4-2.2.2
..................................................................................... 4-5 FM CT Sensitivity
4-2.2.3
............................................... 4-7 Receive AM PT Sensitivity and Distortion
4-2.2.4
..................................................................... 4-9 Receiver AM CT Sensitivity
4-2.2.5
............................................................................... 4-11 CT Audio Response
4-2.2.6
................................................................................. 4-13 Squelch Sensitivity
4-2.2.7
........................................................................................ 4-15 Scan Function
4-2.2.8
............................................................................ 4-17 Signal-Strength Meter
4-2.3.
.................................................................................................. 4-18 Transmitter Tests
4-2.3.1
.......................................... 4-20 Frequency Accuracy and FM Power Output
4-2.3.2
............................................................. 4-22 FM PT Deviation and Distortion
4-2.3.3
............................................................. 4-24 FM CT Deviation and Distortion
4-2.3.4
........................ 4-26 AM Power Output, PT % Modulation and PT Distortion