User's Manual

4-3
Figure 4-1. Receiver Test Equipment Setup
3. Preset the R2600 by performing the following steps.
a. Press the MEM (Memory) key on the R2600 panel for the preset-screen.
b. Use the CURSOR POSITION keys to highlight preset 01.
c. Press the "view preset" softkey. Note: The softkeys are the eight keys under the CRT
screen on the R2600.
d. Using the CURSOR POSITION keys move to the Monitor Frequency position and
enter 115.000 from the R2600 keypad.
e. Move the cursor to Modulation Type and press the "FM" softkey.
f. Move the cursor to the Generate Frequency position and enter 115.000 from the
R2600 keypad.
g. Move the cursor to Modulation Type and press the "FM" softkey.
h. Move the cursor to bandwidth and press the "NARROW 5 kHz" softkey.
i. Move the cursor to the Duplex Offset position and press the "DON'T CARE" softkey.
j. Move the cursor to Synth. Format Sel (Synthesizer Format Select) and select the
"Tone A" softkey.
k. Move the cursor to Freq (Frequency) and enter 01000.0 from the keypad.
l. Move the cursor to the DTMF Code position and press the "DON'T CARE" softkey.
Note: The "more" softkey may have to be depressed for the "DON'T CARE" softkey to
be displayed.