User's Manual

Maintain the environmental seal of the computer by keeping all external access doors closed and latched

Avoid exposing the unit to extreme temperatures or moisture when the doors are open

Periodically backup or archive important files and data.

Hard Drive Installation and Removal

The GoBook MR-1's internal hard drive is accessible from the back of the unit.

To remove the hard drive:

To insert a hard drive:

1. Save and backup any work, and shut down the

computer

2. Hold the computer in both hands and turn over so

you are looking at the bottom with the battery latch

at the back of the unit in your right hand.

3. Place your thumbs on the battery latches on the

either edge of the battery and press in.

3. Lift the battery away from the unit.

1. Hold the GoBook MR-1 as shown and press in

with the finger of your right hand on the latch

next to the hard drive (see circle in illustration)

until you hear it click.

2. Use the thumb on your left hand to slide out the

hard drive.

3. Once the drive is projecting from the GoBook

MR-1, grasp it gently and pull it straight out of

the unit.

1. Place the hard drive in the slot on the GoBook

MR-1 and slide it in straight and slow.

NOTE

Make sure you keep the drive straight and

press gently so as not to damage the exposed hard

drive connector pins.

2. Slowly slide in the drive until the latch clicks

into place.

e 79 of 90GoBook M

-1

8/20/2007file://C:\Documents and Settin

s\harwoodm\Local Settin

s\Tem

\~hh5471.htm