User's Manual

Europe
This product complies with the radio interference protection requirements of the Council Directive
89/336/EC on the approximation of the laws of the Member States of the European Union relating to
electromagnetic compatibility. The product was tested in a typical configuration and found to conform to
the following test specifications:
EN55022: Radiated and conducted emissions. Class B.
EN50082 or EN55024: ESD and radiated and conducted immunity.
For further compliance details, refer to the specific CE Declaration Of Conformity. This is available on
request, please quote the exact and full model number of the product(s) in question.
Warnings and Cautions
CAUTION! Approved accessories only may be used with this equipment. In general, all cables must be of
high quality, shielded, correctly terminated and normally restricted to 2 meters in length. Itronix AC
Adapters employ special provisions to avoid radio interference and should not be altered or substituted.
Unapproved modifications or operations beyond or in conflict with these instructions for use may void
authorization by the authorities to operate this equipment.
WARNING It is important that only authorized Itronix personnel attempt repairs on Itronix equipment as
this might void any maintenance contract with your company. Unauthorized service personnel might be
subject to shock hazard on some Itronix equipment if removal of protective covers is attempted.
The product you have purchased is powered by a rechargeable battery. The battery is recyclable and, under
various state and local laws, it may be illegal to dispose of this battery into the municipal waste stream. Do
not crush the battery or place it in a fire. Check with your local solid-waste officials for details on recycling
options or proper disposal.
CAUTION Internal components of the handheld computer will be damaged if exposed to contaminants.
When dust covers, the PC card door, or the bottom access panel are open on the handheld computer, shield
the unit from all contaminants such as liquids, rain, snow, and dust.
CAUTION: This device was evaluated for body-worn RF exposure compliance using the Carry Case
accessory P/N: 54-0644-001. During body-worn transmit operation, use only the approved Carry Case
P/N. 54-0644-001, in order to comply with FCC RF exposure compliance requirements. When operating
the transmitter during normal handheld use, a 20 cm separation distance must be maintained between the
handheld PC (including the antenna) and all operators/bystanders, in order to comply with FCC RF 
exposure compliance requirements. 

CAUTION: This device can be used with an optional vehicle cradle (Itronix P/N: 50-0107-001) and 
vehicle-mount antenna (MaxRad P/N: WMLPVDB800/1900). The vehicle-mount antenna must be 
placed at least 20 cm from all operators and bystanders in order to comply with FCC RF exposure 
compliance requirements. 

Placement of vehicle-mount antenna: 
1. Measure and identify an area 20 cm (8 inches) in from the edges of the vehicle roof. 
2. Place the antenna within that area. 
Safety Information:
The following safety symbols are used in this manual to indicate potentially dangerous situations. Do not 
proceed beyond a WARNING or CAUTION until the indicated conditions are fully understood and met.