User's Manual

The First Time. . .
Using your computer for the first time involves:

Installing the battery

Connecting the AC adapter to the computer

Turning the Computer On and Off

Adjusting the Volume
Installing the Battery
Make sure the computer is sheltered when you install the Lithium Ion battery; the computer is not weather sealed until
the battery is properly installed. The battery should be fully charged before you operate the unit on battery power. To
get the most from your battery, follow the guidelines in the Power Management section.
To install the battery
1. Remove the battery door.
2. Align the battery connectors and place the battery in the computer.
3. Replace the battery door and rotate the door latches to secure the door.
NOTE
When the battery is installed and the computer is connected to AC power, see Connecting the AC Adapter
below, it starts charging automatically. At moderate temperatures, approximately 70° Fahrenheit (21°C), the battery
will be fully charged in four to six hours. In warmer or cooler temperatures, the battery can take much longer to fully
charge. Refer to the Power Management section for additional information.
Connecting the AC Adapter
To connect the ADP-90AB or ADP-75FB AC adapter
1. Connect the AC adapter power cord to the AC adapter.
2. Connect the AC adapter to the power jack at the rear of your computer.
3. Connect the AC adapter power cord to an AC outlet.
4. Lift the display to open the LCD.
5. Open the LCD panel to a comfortable viewing angle.
6. Press the
Power Button
to turn ON the power.
Turning the Computer On and Off
Page
5
of
74
GoBook II Help
7/31/2003
file://C:\Documents%20and%20Settings\harwoodm.ITRXNT1\Local%20Settings\Temp\~hh9A72.htm