User's Manual

72_0103_003

10 December 2002

Display 

The display performance is slow



The temperature may be too cold. Move the computer to a warmer operating environment. 

I can’t read the display



Adjust the brightness level using

and



The automatic power-saving mode may have shut off (suspended) the computer. Press any key to resume.



If the display brightness is unreadable after a resume or reboot but is easily adjusted with

and

you may have set Stealth mode in the Setup Utility. If you disable Stealth mode the display and

backlight will operate normally.

The underlined, inverse, and hypertext characters are difficult to read on the screen



Change the color scheme. From the Start Menu select Settings, Control Panel, choose Display, and then tap

the Appearance tab to make changes to the color scheme.

I can’t see the cursor while using the DOS editor



Press

INSERT

to change from insert mode to overwrite mode to enable a block cursor. When it

defaults to insert mode, the DOS editor uses an underline cursor which is less visible than the block cursor

for overwrite mode.

The display appears to have random pixels darkened after scrolling



Contact your supervisor or your organization’ s help desk for information about correcting this problem.

I changed my display resolution, but I see no difference on the screen



Try restarting your computer for the changes to take effect. 

GoBook II™ Help



Page

GoBook II Help

7/31/2003

file://C:\Documents%20and%20Settings\harwoodm.ITRXNT1\Local%20Settings\Temp\~hh9A72.htm