User's Manual

z
Make sure the standby time is set properly in the Power Management program.
The system date and time are incorrect
z
Reset the correct date and time by choosing the Date/Time icon from Control Panel and making
the appropriate changes.
I receive an “out of memory” error message
z
Too many applications may be running at the same time. Close applications you don’t need.
z
Run MS-DOS applications in full screen rather than a window. Press
ALT
+
ENTER
to toggle
between full screen and window mode.
z
If you’re using desktop wallpaper, set wallpaper to None. To do this, choose Display from Control
Panel and make the appropriate change.
z
Make sure you have enough space on your hard disk . Contact your supervisor or your
organization’s help desk for assistance.
z
Set up a permanent swap file. Contact your supervisor or your organization’s help desk for
assistance.
Holding down the Power button to reset the computer doesn’t always work
z
Try resetting the computer again. If this doesn’t work, remove all power, including the battery
pack, and allow the unit to remain idle for ten minutes. After ten minutes, connect external power
and retry.
The LED's, backlight, and/or keyboard backlight don't illuminate.
You may have enabled Stealth mode in the Setup Utility. Go to CMOS Setup and disable Stealth mode.
The computer doesn't make any sounds, even during boot-up.
You may have enabled Stealth mode in the Setup Utility. Go to CMOS Setup and disable Stealth mode.
The fan stopped running.
You may have enabled Stealth mode in the Setup Utility. Go to CMOS Setup and disable Stealth mode.
72_0119_001
28 June 2004
©
2004 Itronix Corporation. All rights reserved.
Pa
g
e 77 of 80GoBook III Hel
p
7/5/2004file://C:\Documents%20and%20Settin
g
s\harwoodm.ITRXNT1\Local%20Settin
g
s\Tem
p
\~h...