User's Manual

Pen / Display
 When I try to use the pen on my display, nothing happens
 If you cannot select objects accurately with the pen, you may need to recalibrate the display.
Display calibration depends on the display mode you are using, digitizer mode or touch
screen mode. Press the Line Up + Line Down Keys simultaneously to switch between display
modes. You will hear one beep when entering touch screen mode and two beeps when
entering digitizer mode.
 If you are using a conventional pen/stylus, verify you are in touch screen mode (see above)
 The display warps or pillows in high humidity
The computer remains functional; however, moving the computer to a more suitable environment will
allow the display to recover.
 The touch panel doesn't respond after a suspend
The touch panel needs a few seconds to work after a suspend. Wait a moment and try again.
 I cannot change the orientation
Your screen resolution may be set to low. To increase screen resolution select Start, Control Panel,
Display Properties. Then select the Settings tab and adjust the resolution.
 The display performance is slow
The temperature may be too cold. Move the computer to a warmer operating environment.
 I can’t read the display
 Adjust the brightness level up by pressing FN+Rotate and adjust it down by pressing
FN+Security.
 Your display may be off. Tap your pen on it once.
 If that doesn't work the automatic power-saving mode may have shut off (suspended) the
computer. Press the power button to resume.
 The underlined, inverse, and hypertext characters are difficult to read on the screen
Change the color scheme. From the Start Menu select the Control Panel. Choose Display and then
tap the Appearance tab to make changes to the color scheme.
 I can’t see the cursor while using the DOS editor
Press INSERT on the input panel to change from insert mode to overwrite mode and to enable a block
cursor. When it defaults to insert mode, the DOS editor uses an underline cursor which is less visible
than the block cursor for overwrite mode.
 The display appears to have random pixels darkened after scrolling
Contact your supervisor or your organization’s help desk for information about correcting this
problem.
 I changed my display resolution, but I see no difference on the screen
Try restarting your computer for the changes to take effect.
 The display cuts off the right side of the application or page in portrait mode