Installation Instructions
Dishwasher Installation
STEP 10: SLIDE DISHWASHER THREE-FOURTHS 
OF THE WAY INTO CABINET
IMPORTANT – Do not push against front panel with 
knees. Damage will occur. 
• Grasp the sides of the 
front panel and slide 
dishwasher into the 
opening a few inches 
at a time.
• As you proceed, pull the drain hose through the opening under the 
sink. Stop pushing when the dishwasher extends about 6 inches 
IRUZDUGRIDGMDFHQWFDELQHWV
• Make sure drain hose is not kinked under or behind the dishwasher.
• Make certain the house wiring, drain line and water line do not 
interfere with components under dishwasher.
8
STEP 11: INSTALL TRIM PIECES 
In this step you will need the trim pieces set aside in Step 1.
STEP 12: INSTALL MOUNTING BRACKETS
You will need the mounting brackets and 2 #8 hex-head screws set 
aside in Step 1.
You must install the mounting brackets onto the dishwasher tub 
frame top or sides prior to sliding the dishwasher into place under 
the countertop. This dishwasher is capable of a true-flush installation 
at a 24” deep opening. The mounting brackets have several 
available attachment positions to accommodate different cabinet 
constructions.
Install mounting brackets on top if the underside of 
countertop is wood or wood-like material that accepts screws:
IMPORTANT - After installing brackets and before 
FORVLQJWKHGLVKZDVKHUGRRUDGMXVWWKHEUDFNHWVE\EHQGLQJ
them up as needed, so that they do not contact the top of the 
dishwasher door and cause damage.
• If you are installing the dishwasher under a counter with a short 
overhang, the countertop brackets may extend beyond the edge 
of the counter. If this is the case, remove the excess length by 
repeatedly bending the brackets at the front notch only until they 
break.
Install mounting brackets on sides if the countertop is 
granite or similar material that will not accept wood screws: 
%UHDNRȺIURQWSRUWLRQRIWKHWDEZLWKSOLHUVDWWKHORFDWLRQVKRZQ
prior to attaching to dishwasher.
• Position the left-hand side bracket as shown. Repeat with the right 
bracket.
Dishwasher 
tub frame
#8 Bracket 
Screw
Bracket
Bend and break here 
after installing if 
counter has a short 
overhang.
Top Mounting
• Select the top trim piece (See Figure R) and line up center to the top 
ODWFK3UHVVWKHWULPSLHFHRQWRWKHWXEÀDQJHPRYLQJIURPRQHVLGH
to the other.
• Select the left trim piece (see Figure R).Align top edge with the top 
WULPDQGSUHVVLWRQWRWKHOHIWVLGHRIWKHWXEÀDQJHPRYLQJIURPWKH
WRSWRWKHERWWRP5HSHDWIRUWKHULJKWVLGHWXEÀDQJHWULPSLHFH
(See Figure R for right side trim piece.)
Figure S
Figure Q
Do not push against
front door panel with
knee. Damage to the
door panel will occur.
Side Trim
Figure R
Side 
Trim
Top View
Side 
Trim
Top Trim
)XOO\VHDWWRWXEÀDQJH
Figure T
Bracket
Dishwasher 
tub frame
#8 Bracket 
screw as 
supplied
Side Mounting
Bend and break 
here if necessary
Care should be taken to 
ensure mounting screws 
do not damage cabinetry
Do not pinch 
the latch 
wires in 
#8 bracket 
screw
Tub trim
Top 
View
Handle
Door
Tub trim
Tub frame










