Use and Care Guide

32 49-3000206 Rev 5

Installation Instructions

REVERSING THE DOOR SWING (Optional)

IMPORTANT NOTES

• Handle parts carefully to avoid scratching paint.

• Provide a non-scratching work surface for the door.

• Set screws down by their related parts to avoid using

them in the wrong places.

• Once you begin, do not move the cabinet until

door-swing reversal is completed.

• These instructions are for changing the hinges from the

right side to the left side—if you ever want to switch them

back to the right side, follow these same instructions and

reverse all references to the left and right.

REMOVE THE STRIKE PLATE

AND DOOR ASSEMBLY

• Open the dryer door.

• Remove the two screws from the strike plate using

a T-25 torx driver.

• Remove the strike plate and set it aside.

• While supporting the door, remove the two screws

from the hinge in the dryer face using a 1/4” (6.4 mm)

nut driver.

• Lift the door assembly to remove it from the dryer

face and set it aside on a protective surface.

Phillips-head screwdriver T-25 torx driver 1/4” (6.4 mm) nut driver

TOOLS YOU WILL NEED

BEFORE YOU START

Unplug the dryer from its electrical outlet.

REMOVE THE INNER DOOR

• Remove the 14 screws from the inner door frame

using a Phillips-head screwdriver and set them aside.

• Remove the inner door frame from the outer door.

NOTE: Do not remove the gasket from the inner door

frame.

Hold the Door and

Remove Hinge Screws

from the Dryer

Remove Strike

Plate and Screws

Hinge and Door

Assembly