Use and Care Guide

49-3000206 Rev 5 33

Installation Instructions

REVERSING THE DOOR SWING (Optional)

REMOVE, ROTATE AND REPLACE

THE HANDLE AND HINGE INTO

THE OPPOSITE SIDES

• Lift the handle and the hinge out of the door pockets.

NOTE: Make sure the latch remains seated inside the

handle. If it moves or falls out, seat it back into place.

• Rotate the handle and hinge, and replace them

back into the pockets on the opposite sides.

REPLACE THE INNER DOOR

• Replace the inner door frame into the outer door.

• Replace the 14 screws into the inner door, using a

Phillips-head screwdriver, securing it to the outer door.

NOTE: Make sure the gasket is properly seated on

the inner door frame when replaced.

REPLACE THE STRIKE PLATE

AND DOOR ASSEMBLY

• On the opposite side from where removed, replace

the strike plate with its two screws using a T-25 torx

driver.

• Lift the door assembly into place and secure it onto

the dryer face with its two screws using a 1/4” (6.4 mm)

nut driver.

• Close the dryer door.

NOTE: Make sure the door opens and closes

correctly. If not, repeat all steps making sure the

gasket, all parts, and screws are securely seated.

Hold the Door and

Replace Hinge Screws

into the Dryer

Replace Strike

Plate and Screws