Use and Care Guide

49-3000206 Rev 5 37
Installation Instructions
STACKING THE WASHER AND DRYER
(Optional Kit GFA28KITN)
FINALIZE THE INSTALLATION
6
INSTALL THE DRYER AND THE
BRACKET ON THE WASHER
A. Lift the dryer onto the top of the washer.
Be sure to lift the dryer high enough to clear the
washer control panel.
Be careful not to scratch the top of the washer with
the spacers. Protect the washer control panel with
cardboard or other protection.
B. Align the holes in the back of the dryer with the
holes in the bracket sticking up from the washer.
Attach both brackets to the dryer with 2 screws on
each side.
5
A. Refer to the washer Installation Instructions to
complete the washer installation.
B. Refer to the dryer Installation Instructions to
complete the dryer installation.
C. Carefully slide or walk the stacked washer and
dryer into place. Use felt pads or other sliding
device to assist moving and to protect flooring.
D. Verify the units are level. Make adjustments to
the washer feet if necessary to level. It is always
best to set the washer feet to the minimum height
necessary to level the washer and dryer properly.
Do not push on the dryer once
installed to top of the washer.
Pushing on the dryer may result in pinched
fingers.
CAUTION
Place
hands
here
Place
hands
here
Washer
Dryer
OR
• Use two or more people to install dryer.
• Avoid tipping and rupture of utility services.
• Dryer must be securely attached to the washer.
• DO NOT place the washer on top of the dryer.
Failure to do so may result in serious injury,
death, or property damage.
WARNING
- Excessive Weight
Hazard
Attach
brackets
to dryer
using 2
screws on
each side
N
o
32 Brackets for 32" (81.3 cm) Washer & Dryer
Combinations:
Attach
brackets
to dryer
using 2
screws on
each side
N
o
34 Brackets for 34" (86.4 cm) Washer & 32" (81.3 cm)
Dryer Combinations: