Material Safety Data Sheet

ManualsBrandsGeneral Finishes ManualsFinishes, Sealers & StainsGeneral Finishes QTHS High Performance Water Based Topcoat, 1 quart, Satin

High Performance Satin

Section 7. Handling and storage

Conditions for safe storage,

including any

incompatibilities

Store in accordance with local regulations. Store in original container protected from

direct sunlight in a dry, cool and well-ventilated area, away from incompatible materials

(see Section 10) and food and drink. Keep container tightly closed and sealed until

ready for use. Containers that have been opened must be carefully resealed and kept

upright to prevent leakage. Do not store in unlabeled containers. Use appropriate

containment to avoid environmental contamination.

Section 8. Exposure controls/personal protection

Ingredient name

Hand protection

Chemical-resistant, impervious gloves complying with an approved standard should be

worn at all times when handling chemical products if a risk assessment indicates this is

necessary.

Safety eyewear complying with an approved standard should be used when a risk

assessment indicates this is necessary to avoid exposure to liquid splashes, mists,

gases or dusts. If contact is possible, the following protection should be worn, unless

the assessment indicates a higher degree of protection: safety glasses with side-shields.

Eye/face protection

Body protection

Personal protective equipment for the body should be selected based on the task being

performed and the risks involved and should be approved by a specialist before

handling this product.

Environmental exposure

controls

Emissions from ventilation or work process equipment should be checked to ensure

they comply with the requirements of environmental protection legislation.

Appropriate engineering

controls

Good general ventilation should be sufficient to control worker exposure to airborne

contaminants.

Wash hands, forearms and face thoroughly after handling chemical products, before

eating, smoking and using the lavatory and at the end of the working period.

Appropriate techniques should be used to remove potentially contaminated clothing.

Wash contaminated clothing before reusing. Ensure that eyewash stations and safety

showers are close to the workstation location.

Hygiene measures

Control parameters

Individual protection measures

Occupational exposure limits

Skin protection

Other skin protection

Appropriate footwear and any additional skin protection measures should be selected

based on the task being performed and the risks involved and should be approved by a

specialist before handling this product.

(2-Methoxymethylethoxy)propanol

ACGIH TLV (United States, 3/2016). Absorbed through skin.

STEL: 150 ppm 15 minutes.

TWA: 606 mg/m³ 8 hours.

TWA: 100 ppm 8 hours.

STEL: 909 mg/m³ 15 minutes.

NIOSH REL (United States, 10/2013). Absorbed through skin.

STEL: 900 mg/m³ 15 minutes.

STEL: 150 ppm 15 minutes.

TWA: 600 mg/m³ 10 hours.

TWA: 100 ppm 10 hours.

OSHA PEL (United States, 6/2016). Absorbed through skin.

TWA: 600 mg/m³ 8 hours.

TWA: 100 ppm 8 hours.

Exposure limits

4/9

Tel : +1-888-GHS-7769 (447-7769) / +1-450-GHS-7767 (447-7767)