Instructions / Assembly

Assembly And Shaping Instructions
ASSEMBLY: PLEASE READ COMPLETE INSTRUCTIONS BEFORE PROCEEDING.
THE TREE IDENTIFICATION NUMBER IS LOCATED ON THE END PANEL OF THE
TREE CARTON. ALWAYS REFER TO THIS NUMBER IN ANY COMMUNICATION
CONCERNING YOUR TREE.
1. REMOVE ALL PARTS FROM CARTON (FIG.1)
SEPARATE BRANCH PANELS ACCORDING TO THE
MARKING ON THE END OF EACH PANEL.
NOTE: BRANCH PANELS ARE NOT SHAPED, REFER TO
SHAPING INSTR UCTIONS WHEN ASSEMBLING.
3. INSERT THE BOTTOM POLE INTO STAND BODY
WITH THE TABS OF LOCK RING POINTED TOWARD
THE STAND BODY. WITH THE POLE SEATED
FIRMLY AGAINST THE BOTTOM OF THE STAND,
SLIDE THE LOCKING RING DOWN THE POLE AND
PRESS FIRMLY IN PLACE WITH THE TABS ALIGNED
BETWEEN THE RIBS INSIDE THE STAND. THE
POLE IS NOW LOCKED INTO THE TREE STAND.
INSERT THE TAPERED END OF THE MAIN POLE
INTO THE TOP END OF THE BOTTOM POLE.
4. PLACE TREE TOP IN TOP CAP AT THE END OF
POLE AND PRE-SHAPE THE TOP THEN REMOVE
AND SET ASIDE.
5. COVER POLE BY TWISTING POLE WRAP
AROUND THE POLE. STARTING AT THE BOTTOM,
INSERT COLOR CODED BRANCH PANELS INTO
APPROPRIATE BRANCH HOLDER. SHAPE EACH
LAYER AS YOU GO, REFERRING TO REVERSE SIDE.
6. PLACE PRE-SHAPED TOP ON TOP OF POLE
AND COMPLETE SHAPING AS INSTRUCTED.
084-121025
REFER TO TREE TOP SHAPI NG
I NSTRUCTI ONS ON REVERSE
BEFORE PROCEEDI NG!
REFER TO
TREE TOP SHAPING
INSTRUCTIONS
ON REVERSE
BEFORE PROCEEDING!
BRANCH
PANEL
BRANCH HOLDER
LEGS
STAND BODY
POLE
WRAP
LOCK RING
4 Each #8
4 Each #10
4 Each #10
4 Each #6
4 Each #12
4 Each #16
2. ASSEMBLE STAND LEGS TO STAND BODY BY SLIDING
WIDE END OF LEGS INTO SLOTS ON UNDERNEATH OF
STAND BODY. SEAT LEGS FIRMLY IN SLOTS.
4 Each #14
TREE TOP
NUMBER