Instructions / Assembly

Top
View
Side
View
1) Before you start to assemble your tree, choose a location near a wall outlet.
2) Carefully remove contents from the carton. Contents will include:
1) Tree Top- Section A
2) Bottom Tree- Section B
3) Tree Stand
4) Extra Bulbs/ Fuses
DO NOT DISCARD CARTON! Use for Tree Storage.
CAUTION: MAKE SURE ALL LIGHT WIRES & HANDS ARE CLEAR OF BRANCH HINGES.
3) Insert the bottom tree section into the stand body. Allow the branches to fall into place or
gently pull them out and down.
4) Place the tree top into the bottom tree section pole. Plug in the light set from the tree top
section into the extension cord. Then the extension cord to the wall outlet.
CAUTION: MAKE SURE ALL LIGHT WIRES & HANDS ARE CLEAR OF BRANCH HINGES.
6) Your entire tree should now be lit. If some bulbs do not light, search for any broken or loose
plugs or missing bulbs.
7) Keep tree plugged in while shaping your tree. Should a light flicker while doing this, check for
the bulb that may have caused the trouble.
8) Begin to shape the branches working from the bottom to the top. Start
with tips farthest from the pole, one to the right, one to the left, and
one at the center of the main stem.
9) After shaping the whole tree following the previous steps, step back and take an overall look
at the tree. Shift branches to fill any gaps. Slightly up sweep all branch tips for a uniform
look. Your tree is now ready to decorate and enjoy.
1) Unplug extension cord from wall outlet.
2) Unplug the tree sections from the extension cord. Keep stacks plugged
together.
3) Gently lift off the top tree section. Remove the bottom section from the stand.
4) Carefully place the tree sections back in the storage carton and tape it shut. Store carton in a
cool, dry place where the temperature does not exceed 100 degrees Fahrenheit.
2-05 084-120391
ASSEMBLY INSTRUCTIONS FOR LIGHTED TREE
UNPACKING, ASSEMBLY and SHAPING
DISASSEMBLY and STORAGE
Caution: Carefully Read Instructions and Procedures for Safe Operation
MODEL L203