Owner manual

ManualsBrandsGeneral Hydroponics ManualsGardening equipmentAF36

AeroFlo

Assembly Guide

For quite a while now, satisﬁed AeroFlo2 users have

requested a compact AeroFlo2 model designed expressly

for indoor lighting. General Hydroponics is pleased to offer

the trim line Model 36 with a large 40 Gallon reservoir. The

Model 36 is designed to ﬁt an indoor grow light.

Summary of content (6 pages)

PAGE 1
2 AeroFlo ® 36 Assembly Guide For quite a while now, satisfied AeroFlo2 users have requested a compact AeroFlo2 model designed expressly for indoor lighting. General Hydroponics is pleased to offer the trim line Model 36 with a large 40 Gallon reservoir. The Model 36 is designed to fit an indoor grow light.
PAGE 2
AeroFlo2 36 PARTS 15 18 4 16 3 2 11 1 12 8 13 14 6 17 19 10 9 5 7 AeroFlo2 36 PARTS: assembled dimensions: 4’2”L X 4’7”W X 2’H 1: 2: 3: 4: 5: 6: 7: 8: 9: Panda Reservoir (40 gal) Reservoir Lid Hatch Cover Growing Chambers (6) Laser Spraylines (6) Drain Level tubes (6) Manifold Silicon Grease Pump Line 10: Drain Valve 11: WaterPower 85 Pump 12: Flora Series Nutrient 13: Net Pots (36) 14: CocoTek Liners (36) 15: Clay Pebbles (9 Liter) 16: SnapStand Base (2) 17: SnapStand Cross Fittings (2)
PAGE 3
ASSEMBLY STEP 1 Place the Reservoir where it will be used on a level surface. Line the inside of the Reservoir grommet with a thin coat of the Silicon Grease. Insert Drain Valve into grommet using a twisting motion. STEP 2 Attach the pipe thread adaptor provided with the WaterPower 85 Pump to the outlet. Then attach the Pump Line to the outlet adaptor; making sure the Pump Line is fully seated against the “O” Ring.
PAGE 4
ASSEMBLY & HELPFUL GUIDELINES STEP 6 Attach the Manifold to the Pump Line and attach each of the Laser Spraylines to the Manifold. Make sure there is a rubber gasket in the Laser Sprayline fitting and DO NOT OVER TIGHTEN. The level of the water in the Growing Chambers is controlled by the height of the Drain Level Tube. Keep the Drain Level Tube access covered after adjusting the water level.
PAGE 5
HELPFUL GUIDELINES PLACEMENT Abundant light, proper temperature and adequate ventilation are crucial for fast growth, healthy plants and higher yields. Place the AeroFlo2 system in a warm, well-lit, well-ventilated location, such as an outdoor garden, sunlit window, patio or greenhouse. Keep your AeroFlo2 away from areas where the inevitable dripping that occurs during filling, draining and pH adjustment could cause water damage.
PAGE 6
TROUBLE SHOOTING If white salt deposits form on the clay pebbles: 1. Try using a milder nutrient solution and topping off with plain water only. 2. Occasionally drain your system, refill with plain water and run the pump overnight. After the overnight rinse, empty reservoir and refill with fresh nutrient. If plants are not growing well and you suspect “hard” water: 1. Use FloraMicro Hardwater in place of FloraMicro. 2. Try distilled or purified water.