Owner's manual

ASSEMBLY ASSEMBLY
STEP 9
Connect the manifold to the Dual Diaphragm Air Pump and connect each of the individual
growing units using the airline tees (that are packaged with the Dual Diaphragm Air
Pump) to the Pumping Column airline.
STEP 8
Arrange the individual growing units
in two lines or any configuration
that fits your growing conditions.
Measure and cut the ½” Blue Tubing
to connect each of the individual
growing units.
STEP 7
Attach a Drip Ring to
each of the Pumping
Columns, ensuring the
holes in the Drip Ring
are facing downwards.
Insert the Pumping
Column assembly into
the Pumping Column
Support tube for each
of the growing units.
STEP 6
Place the Growing
Chamber on each
of the Individual
Reservoirs and insert
the Pumping Column
Support Tube in
the large hole in
the bottom of the
Growing Chamber.
STEP 10
Move the Drip Rings out of the way
and fill the system with the Media
of your choice. Clay pebbles are the
recommend media because of its
ease of use and durability for reuse.
It is also very efficient in delivering
the right amount of water to the
root system without over watering.
The WaterFarm 8-Pack circulating pump pulls nutrient solution from the first individual
reservoir and mixes with the nutrient solution in the controller, then flows out through
the opposite individual reservoir because of the difference in the level of the nutrient
solution. The entire system will cycle in approximately 4 hours end effectively maintain
a consistent nutrient in all of the individual reservoirs.