Full Product Manual

INSTALLING THE TABLE

3. Center the head stock with the column and the

table.

4. Secure the head stock to the column by tighten-

ing screws A & B using a 5 mm Allen key.

1. Make sure that arbor A is to the right and the table

bracket is centered on the column. Turn the brack-

et if needed as shown.

2. Hold the table against the bracket aligning the

mounting holes as shown.

3. Tighten bolt B hand tight for now. 4. Turn the table until the zero point of the table

bracket and the table are aligned as shown C.

BEFORE ASSEMBLING, MAKE SURE THAT THE SWITCH IS IN THE “OFF” POSITION AND THAT THE POWER CORD IS UN-

PLUGGED. DO NOT PLUG IN OR TURN ON THE MACHINE UNTIL YOU HAVE COMPLETED THE ASSEMBLY AND INSTALLATION

STEPS DESCRIBED IN THIS SECTION OF THE MANUAL.