Manualshelf

Full Product Manual

ManualsBrandsGeneral International ManualsDrill Presses12 in. Drill Press with Variable Speed and Laser System
11121314151617181920
13
INSTALLING THE DOWNFEED HANDLES
2. Tighten each handle using a 9 mm wrench.1. Thread the three downfeed handles into their
mounting holes located in the support B.
INSTALLING THE SPEED CONTROL LEVER
2. Tighten the handle using a 9 mm wrench.1. Thread the handle into its mounting hole located
in the bracket C.
B
C
MAKE SURE THE MACHINE HAS BEEN TURNED OFF AND UNPLUGGED FROM THE POWER SOURCE BEFORE PERFORMING
ANY MAINTENANCE OR ADJUSTMENTS.
INSTALLING THE CHUCK
2. Clean inside the chuck with a dry cloth until all
grease or lubricant is removed.
1. Lift the chuck guard as shown.