Instructions / Assembly

4. Make sure the arbor is inserted all the way into the

chuck.

3. Fit the arbor into the chuck as shown.

6. Using the feed handles, lower the chuck against

a piece of wood on the table to pressﬁt it into the

quill.

5. Slide the arbor into the quill assembly as shown.

MAKE SURE THE MACHINE HAS BEEN TURNED OFF AND UNPLUGGED FROM THE POWER SOURCE BEFORE PERFORMING

ANY MAINTENANCE OR ADJUSTMENTS.

REMOVING THE CHUCK

2. While holding onto the chuck, tap gently on the

key with a hammer or rubber mallet to loosen and

remove the arbor and chuck.

Note: It may be necessary to rotate the quill in order to be

able to get the tool all the way through D.

1. Using feed handle, lower the quill assembly A. In-

sert the drift key B all the way into the quill assem-

bly C.