Use and Care Manual

15
BASIC ADJUSTMENTS & CONTROLS
CONNECTING TO A POWER SOURCE
Once the assembly steps have been completed, plug
the power cord into an appropriate outlet.
Refer back to the section entitled “Electrical Require
-
ments” and make sure all requirements and grounding
instructions are followed.
When operations have been completed unplug the
machine from the power source.
2. Secure the drill bit in the chuck by turning the key
clockwise.
1. Open the chuck by turning the key E counter-
clockwise until you can insert a drill bit F.
INSTALLING A DRILL BIT
F
E
TO REDUCE THE RISK OF SHOCK OR FIRE DO NOT OPERATE THE UNIT WITH A DAMAGED POWER CORD OR PLUG. RE-
PLACE DAMAGED CORD OR PLUG IMMEDIATELY. TO AVOID UNEXPECTED OR UNINTENTIONAL START-UP, MAKE SURE
THE POWER SWITCH IS IN THE OFF POSITION BEFORE CONNECTING TO A POWER SOURCE.
MAKE SURE THE MACHINE HAS BEEN TURNED OFF AND UNPLUGGED FROM THE POWER SOURCE BEFORE PERFORMING
ANY MAINTENANCE OR ADJUSTMENTS.
SWITCH OFF
TO AVOID UNEXPECTED OR UNINTENTIONAL START-
UP, MAKE SURE THAT THE POWER SWITCH IS IN THE
OFF POSITION BEFORE CONNECTING TO A POWER
SOURCE.
ON/OFF POWER SWITCH
This drill is equipped with a forced opening line interrupter switch located on the front which requires machine
restart in case of power failure or circuit interruption.
To start the machine, pull up the switch cover and press the start button "I", A.
To stop the machine, press directly on the switch cover B.
To turn on the laser pointer, set the switch C in the "I" position. To turn off the laser pointer, set the switch in the "O"
position.
LASER POINTER SWITCH
A
POWER OFF
B
C
POWER ON