Use and Care Manual

MAKE SURE THE MACHINE HAS BEEN TURNED OFF AND UNPLUGGED FROM THE POWER SOURCE BEFORE PERFORM-

ING ANY MAINTENANCE OR ADJUSTMENTS.

INSTALLING THE TABLE (MODEL 75-510 ONLY)

3. Slide the table onto the pin. 4. While an assistant holds the table in position, insert

the bolt B into the large mounting hole.

5. Tighten the bolt with a wrench.

6. Thread nut C onto the centering pin and tighten

using a 13 mm wrench.

Note: To install the table crank handle, follow steps 8 to 9

in the previous section.

2. Align the smallest mounting hole in the table with

the pin.

1. Insert the threaded centering pin A into the small-

est hole of the table bracket as shown