Use and Care Manual

4. Place a combination square flat on the table with
the heel of the square flat against the saw blade.
3. Lower the table until it sits on top of the bolt.
4. If the pointer needs to be adjusted, loosen the
screw on the pointer of the front trunnion and
adjust the pointer to the 0 point on the scale. Then
re-tighten the screw to secure the pointer in place.
You will now be able to accurately return the table to
the 90º position automatically without further adjust-
ments and scale reading for any angle other than 0°
will also be accurate.
3. Level the table until it is exactly 90° to the saw
blade then tighten the jam nut against the saw
cabinet .
Note: With the table set to 90º and the stop bolt at
the correct height, make sure the table tilt angle indi-
cator pointer is set to read 0º.
CLOSE UP
INSTALL THE BLADE GUARD HEIGHT ADJUSTMENT HANDWHEEL
2. Tighten with the supplied 5 mm Allen key to secure
the handwheel on the shaft.
CLOSE UP
1. Install the handwheel on the shaft , located on
the right side of the upper wheel cover, by aligning
the flat surface of the shaft with the Allen bolt
already mounted on the handwheel .
TABLE UNDERSIDE VIEW
13