Use and Care Manual

27. Make sure that the switch is in the “OFF” position before
plugging in the power cord.
28 Never leave the machine unattended while it is run-
ning or with the power on. Don't leave tool until it
comes to a complete stop
29. Use of parts and accessories NOT recommended by
GENERAL® INTERNATIONAL may result in equipment
malfunction or risk of injury.
30. Never stand on machinery. Serious injury could result
if the tool is tipped over or if the cutting tool is uninten-
tionally contacted.
31. Make sure the tool is properly grounded. If equipped
with a 3-prong plug it should be used with a three-pole
receptacle. Never remove the third prong.
32. Do not use this bandsaw for other than its intended
use. If used for other purposes, GENERAL® INTERNA-
TIONAL disclaims any real implied warranty and holds
itself harmless for any injury, which may result from
that use.
33.
Regularly inspect the machine for signs of damage
or wear. Before further use of the tool, a guard or
other part that is damaged should be carefully
checked to determine that it will operate properly
and perform its intended function - check for align-
ment of moving parts, binding of moving parts,
breakage of parts, mounting, and any other condi-
tions that may affect its operation.
34. Direction of feed. Feed work into a blade or cutter
against the direction of rotation of the blade or cut-
ter only.
35. The installer shall follow local regulations and
National Electrical Code, ANSI/NFPA 70 installation
requirements.
36. This tool should be connected to a grounded metal
permanent wiring system; or to a system having an
equipment-grounding conductor.
RULES FOR SAFE OPERATION (CONT’D)
To help ensure safe operation, please take a moment to learn the machine’s applications and limitations, as well as poten-
tial hazards. General® International disclaims any real or implied warranty and holds itself harmless for any injury that
may result from improper use of its equipment.
6