GMP 2000 CABINET BALCONY #79281 ASSEMBLY INSTRUCTIONS Installation practice #2001-00054-OSP 3111 Old Lincoln Highway Trevose, PA 19053-4996 Tel: 215-357-5500 Fax: 215-357-6216 E-mail: info@GMPtools.
GMP #27761 Page 2 of 8
STEP 1 GMP 2000 CABINET BALCONY AS RECEIVED W AR NI NG : DO NOT REMOVE WIRE TIE FROM SEAT LOCKING MECHANISM UNTIL BALCONY INSTALLATION IS COMPLETE! BURLAP BAG CONTAINING HARDWARE WARNING: 1. IT IS IMPERATIVE TO TRANSPORT THE BALCONY, AS RECEIVED FROM THE MANUFACTURER AND NOT UNPACK IN ANY WAY, SINCE THE LOCKING DEVICE HARDWARE ALIGNMENT AND UNIT STRUCTURE ARE CRITICAL TO PROPER PLACING. 2. ONCE TRANSPORTED TO THE WORK LOCATION, REMOVE THE PACKING (EXCEPT FOR THE LOCKING MECHANISM TIE).
STEP 2 A C ENTRANCE STEP BRACKET R.H. QUANTITY = 1 ENTRANCE STEP L.H. QUANTITY = 1 B ENTRANCE STEP R.H. QUANTITY = 1 D ENTRANCE STEP BRACKET L.H. QUANTITY = 1 E POLE BRACE QUANTITY = 2 F STEP QUANTITY = 1 UNPACK THE CONTENTS OF THE BURLAP BAG AND LOCATE THE ABOVE PARTS.
STEP 3 UNFOLD BACK SUPPORT TO UPRIGHT POSITION POSITION GUARDRAILS AND SECURE WITH HARDWARE STEP 4 ASSEMBLE ENTRANCE STEPS, ITEMS A & B, TO BALCONY USING THE HARDWARE INDICATED AND HAND TIGHTEN.
STEP 6 ATTACH THE STEP, ITEM F, TO THE SLOPED BRACE DETERMINED TO BE THE ENTRANCE SIDE OF THE BALCONY BASED ON LOCAL OR CORPORATE SAFETY PROCEDURES USING THE HARDWARE INDICATED AND HAND TIGHTEN. STEP 7 BALCONY SUPPORT BRACKETS RAISE THE BALCONY TO THE PROPER HEIGHT, ALIGNED WITH THE CROSS-CONNECT TERMINAL AND ATTACH THE BALCONY SUPPORT BRACKETS TO THE POLE USING APPROVED PROCEDURES AND HARDWARE ALLOWING 6 INCHES CLEARANCE BELOW THE BOTTOM EDGE OF THE CROSS-CONNECT TERMINAL AND THE BRACKETS.
STEP 5 ATTACH THE ENTRANCE STEP BRACKETS, ITEMS C & D, TO THE BALCONY USING THE HARDWARE INDICATED AND HAND TIGHTEN.
STEP 8 ATTACH THE POLE BRACES, ITEM E, TO THE BALCONY USING THE HARDWARE INDICATED AND HAND TIGHTEN. ATTACH THE POLE BRACES TO THE POLE USING APPROVED PROCEDURES AND HARDWARE. IMPORTANT! TIGHTEN ALL BOLTS. REMOVE THE TIE HOLDING THE SEAT LOCKING MECHANISM. ASSURE THE SEAT IS ABLE TO SECURELY LOCK WHEN RAISED TO THE STOWED POSITION.
